Electrolux E23BC68JPS オーナーマニュアル
22
Changing The Water and Air Filters
Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all the
water used to produce ice. The air filter removes odors
and impurities from the refrigerator compartment.
air filtering systems. The water filter system filters all the
water used to produce ice. The air filter removes odors
and impurities from the refrigerator compartment.
Replacement
Water Filter
Remove Two
Protective Caps
Push Water Filter Button
Water Filter
Button
Water Filter
Cartridge
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.
status of your water and air filters. See the Controls
section for more information.
About your advanced water filter
The PureAdvantage
TM
NGFC-2000 filter
system is tested and certified by NSF
International to NSF/ANSI Standards
42 and 53 for the reduction of claims
specified on the performance data sheet.
International to NSF/ANSI Standards
42 and 53 for the reduction of claims
specified on the performance data sheet.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
• Rated Capacity - 240 gallons
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure:
30 pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
Water filter
The water filter is located at the lower left side of the
fresh food compartment.
fresh food compartment.
Replacing your PureAdvantage
TM
water
filter
In general, you should change the water filter every
six months to ensure the highest possible water
quality. The Water Filter Status light on the Touch
Panel prompts you to replace the filter after the six
month time period has elapsed. The water filter
status light on this model is not performance tested
or certified by NSF.
six months to ensure the highest possible water
quality. The Water Filter Status light on the Touch
Panel prompts you to replace the filter after the six
month time period has elapsed. The water filter
status light on this model is not performance tested
or certified by NSF.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
time (during moving for example), change the filter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of
water released during the filter replacement.
the filter. Be ready to wipe up any small amounts of
water released during the filter replacement.
1 Push the filter release button above the
cartridge to disconnect it.
2 Slide the old water filter cartridge straight out
of the housing and discard it.
3 Unpack the new filter cartridge and remove
the two protective caps covering the inlet
and exit of the filter. Slide the filter gently into
the housing until it stops against the snap-in
connector at the back of the housing.
and exit of the filter. Slide the filter gently into
the housing until it stops against the snap-in
connector at the back of the housing.