Electrolux EI23BC30KS オーナーマニュアル
10
Once both doors are in place, ensure they are
aligned with each other and level (please see
the “Installation” section for more details), and
replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure
position where they cannot fall and
cause personal injury, or damage to the
doors or handles.
To remove the refrigerator doors:
1 Trace lightly around the door’s top hinges
1 Trace lightly around the door’s top hinges
with a pencil. This makes reinstallation easier.
2 Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
Lower Hinge Removal
Removing the Doors
Getting through narrow
spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see “Installation” section).
3 Remove any food from the door shelves
and close the doors.
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left
1 Open freezer drawer.
2 Remove drawer screws on right and left
sides (two screws on each side).
3 Lift drawer up and out to remove.
Remove
Hex
Head Drawer
Screw
Remove hex
head drawer
screw
Remove
Hex
Head Drawer
Screw
Remove hex
head drawer
screw
Do Not Remove
Other Screws
CAUTION
Drawer is heavy. Use caution when lifting.
3 Unscrew the three lower hinge screws
and hinge if necessary.
To reinstall the right door, reverse the above steps.
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Top Hinge
Cover
Hinge
Screws
Multi-wire
Multi-wire
Cables
Leave
Hinge
With
Door
Front
Cover Screw