Electrolux EI23BC30KS オーナーマニュアル
25
Changing the Water and Air Filters
Your refrigerator is equipped with separate
water and air filtering systems. The water filter
system filters all the water used to produce
ice. The air filter removes odors and impurities
from the refrigerator compartment.
Replacement
Water Filter
Remove Two
Protective Caps
Push Water Filter Button
Water Filter
Button
Water Filter
Cartridge
NOTE
The control panel includes controls to
monitor the status of your water and air
filters. See the Controls section for more
information.
About your advanced water filter
The
PureAdvantage
TM
NGFC-
2000 filter system is tested and
certified by NSF International to
NSF/ANSI Standards 42 and
53 for the reduction of claims
specified on the performance
data sheet.
Do not use with water that is microbiologically
unsafe or of unknown quality without
adequate disinfection before or after the
system. Systems certified for cyst reduction
may be used on disinfected waters that may
contain filterable cysts.
• Rated Capacity - 240 gallons
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
Water filter
The water filter is located at the lower left side
of the fresh food compartment.
Replacing your PureAdvantage
TM
water filter
In general, you should change the water
filter every six months to ensure the highest
possible water quality. The Water Filter Status
light on the Touch Panel prompts you to
replace the filter after the six month time
period has elasped. The water filter status
light on this model is not performance tested
or certified by NSF.
If your refrigerator has not been used for a period
If your refrigerator has not been used for a period
of time (during moving for example), change the
filter before reinstalling the refrigerator.
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Push the filter release button above the
1 Push the filter release button above the
cartridge to disconnect it.
2 Slide the old water filter cartridge straight
out of the housing and discard it.
3 Unpack the new filter cartridge and
remove the two protective caps covering
the inlet and exit of the filter. Slide the
filter gently into the housing until it stops
against the snap-in connector at the
back of the housing.