Electrolux E23BC78ISS 配線リファレンス
service data sheet
242047002
ice & Water - aUtOMatic deFrOst
BOttOM FreeZer - r134a
iMpOrtant saFety nOte
The information provided herein is designed to assist qualified repair personnel only.
Untrained persons should not attempt to make repairs due to the possibility of electrical
shock. Disconnect power cord before servicing this appliance.
iMpOrtant
If any green grounding wires are removed during servicing, they must be returned to
their original position and properly secured.
Untrained persons should not attempt to make repairs due to the possibility of electrical
shock. Disconnect power cord before servicing this appliance.
iMpOrtant
If any green grounding wires are removed during servicing, they must be returned to
their original position and properly secured.
caUtiOn
all electrical parts and wiring must be shielded from torch flame. dO nOt allow
torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F.
excessive heat will distort the plastic liner.
torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F.
excessive heat will distort the plastic liner.
nOte
This product comes equipped with an Adaptive Defrost Control (ADC). To activate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A “d” in the freezer temperature window and “F” in the refrigerator
temperature window will display when the heater is activated. To deactivate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A “d” and “F” will be displayed until the defrost cycle is complete.
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A “d” in the freezer temperature window and “F” in the refrigerator
temperature window will display when the heater is activated. To deactivate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A “d” and “F” will be displayed until the defrost cycle is complete.
PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT 37°/0° CONTROL SETTING
Type A with Run/Start Capacitor
65°F (18°C) Ambient
90°F (32°C) Ambient
Operating Time
90 to 100%
100%
Freezer Temperature
-5° to 2° F (-20° to -17° C)
-1° to 3° F (-18° to -16° C)
Refrigerator Temperature
34° to 39° F (1° to 4° C)
34° to 39° F (1° to 4° C)
Low Side Pressure
-2 to 6 psig ( -14 to 41 kPa)
-2 to 6 psig (-14 to 41 kPa)
High Side Pressure (last 1/3 cycle)
85 to 105 psig (586 to 724 kPa)
120 to 135 psig (827 to 931 kPa)
Wattage (last 1/3 cycle)
30 to 50
50 to 70
Amps (running)
.4 to .8
.7 to .9
Base Voltage
115 vac (127 vac max)
deFrOst speciFicatiOns
Cabinet Size
thermostat
heater
Cut-in
Cut-out
Watts
Ohms
26’ & 28’ SD, 23’ CD
25° F (-4° C)
47° F (8° C)
500
26.5
Electronic Timer - (ADC) Defrost 24 minutes every 6-96 hours of compressor run time.
cOndenser Fan MOtOr
Watts
rpM
amps
3.1
1100 CW Opposite Shaft
0.03 Running
ice MaKer speciFicatiOns
Electrical
115 vac (127 vac max)
Thermostat
Opens at 48° F ( 9° C), Closes at 15° F ( -9° C)
Heater Voltage
85 vac
ice MaKer cOnnectOr pLUG cOnnectiOns
Wire number
Wire color
connects to:
1
Green/Yellow
Ground
2
Yellow
Water Valve
3
Black
Line
4
Light Blue
Neutral
iMpOrtant
pLease retUrn this sheet tO it’s OriGinaL LOcatiOn.
FREEZER iCE MAKER iNFORMATiON
(Where Applicable)
Test Cycling: Remove cover by inserting screwdriver
in notch at bottom and prying cover from housing. Use
screwdriver to rotate motor gear counterclockwise until
holding switch circuit is completed. All components of ice
maker should function to complete the cycle.
maker should function to complete the cycle.
Water Fill Volume: The water fill adjustment screw
will change the fill time. One full turn is equal to 20cc
(.68 oz.). The correct fill is 102 to 130cc (3.4 to 4.3 oz.).
When a water valve is replaced, the fill volume must be
checked.
TU
R
N
Mounting
Plate
Screws
Plate
Screws
Mounting
Plate
Screw
Plate
Screw
Motor
Gear
Gear
Timing
Gear
Water Fill
Adjustment
Adjustment
POWER
ICE MAKER
I
CE
MAKER
ICE
MAKER
W
A
A
TER
V
A
L
V
E
LINE
THERMAL
CUT-OUT
HOLD
SWITCH
THERMOSTAT
SHUT-OFF
SWITCH
WATER FILL
SWITCH
MOLD HEATER
MOLD
MOUNTING
PLATE
165 WATTS
MOTOR
NEUTRAL
BLK
BLK
BLK
BLK
BLU
C
C
C
NO
NO
NO
NC
NC
NC
LT. BLU
L
T
.
BLU
BRN
RED
GRN / YEL
GR
N
/
YEL
RED
RED
YEL
YEL
YEL
P-3
P-1
P-2
P-4
ICE MAKER
ice Maker errors displayed on “Ui”
diagnostic Mode
note: see service Manual for
complete description.
errOr
test
Activate: Hold FF (+) and FZ (+) for 5 sec.
none
52c
Ice tray thermistor temperature displayed - OK, OP open, SH short
55c
Water valve test
57c
Fan test, on or off
58c
Ice level sensor switch test
63c
Harvest motor system test
de-activate: hold FF (+) for 5 sec.
de-activate: hold FF (+) for 5 sec.
system error codes displayed on “Ui”
diagnostic Mode
note: see service Manual for
complete description.
errOr
test
activate: FZ (+) and FZ (-) for 5
sec.
sec.
Op or 2
Freezer Sensor OPEN
1
Standard compressor
22
Damper
sh or 3
Freezer Sensor SHORTED
2
Defrost heater
23
Fresh food door
Op or 2
FF Sensor OPEN
3
FF lighting
24
Freezer door
sh or 3
FF Sensor SHORTED
8
Water valve,water disp.
26
Defrost limit switch
sy
eF
Evaporator Fan Circuit
9
FZ lighting
28
Dispenser paddle
sy
ce
Communication error
10
Auger motor
36
Ice door
sy
cF
Communication error
11
Cube/crush solenoid
29
FF Thermistor
41
Perfect Temp Drawer
30
FZ Thermistor
12
VCC Condensor fan
33
Ambient Thermistor
To initiate manual defrost press and hold, for 5 sec. FF(+) and FF(-), (d) and (f) will
be displayed.
be displayed.
38
VCC Compressor
0-
Software version
dF
In Manual Defrost (See Note)
15
Evaporator fan
de-activate: hold FF (+) for 5 sec.
de-activate: hold FF (+) for 5 sec.