Electrolux EI23CS35KS 配線リファレンス
242164701
ELECTROLUX SxS
TU
R
N
Mounting
Plate
Screws
Plate
Screws
Mounting
Plate
Screw
Motor
Gear
Gear
Timing
Gear
Water Fill
Adjustment
Adjustment
Ice Maker
ON/OFF
Switch
ON/OFF
Switch
ice Maker inFOrMatiOn
test cycling
Press the momentary contact on the ON/OFF switch for approximately 15 seconds. Ice maker will continue to
complete the cycle.
complete the cycle.
Water Fill volume
The water fill can be adjusted without removing the
ice maker cover. To adjust the fill size, remove the
small round plug next to the On/Off Switch. Insert a
#2 Phillips screwdriver into the hole about an inch or
until it engages the Water Fill Adjustment Screw. Turn
the screw clockwise to reduce the fill size; turn the
screw counterclockwise to increase the fill size. One
turn equals approx 20cc (0.68 oz). The correct fill is
85 to 95cc (2.75 to 3.25 oz). When a water valve is
replaced, check the fill volume.
ice maker cover. To adjust the fill size, remove the
small round plug next to the On/Off Switch. Insert a
#2 Phillips screwdriver into the hole about an inch or
until it engages the Water Fill Adjustment Screw. Turn
the screw clockwise to reduce the fill size; turn the
screw counterclockwise to increase the fill size. One
turn equals approx 20cc (0.68 oz). The correct fill is
85 to 95cc (2.75 to 3.25 oz). When a water valve is
replaced, check the fill volume.
ice Maker speciFicatiOns
Electrical
115 vac (127 vac max)
Thermostat
Opens at 48° F ( 9° C), Closes at 9° F ( -13° C)
Heater Wattage
112 watts
ice Maker cOnnectOr pLUG cOnnectiOns
Wire number
Wire color
connects to:
1
Green/Yellow
Ground
2
Yellow
Water Valve
3
Black
Line
4
Light Blue
Neutral