Electrolux EI30ES55JS 仕様シート

Electric Built-In Range

•

Product Weight – 238 Lbs.

•

Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz,
fused on both sides of line with ground. (If local code permits, range may
be connected by hard-wiring or by means of power supply cord kit.)

•

Connected Load (kW Rating) @ 240 / 208 Volts = 15.3 / 11.7 kW 

•

Amps @ 240 / 208 Volts = 63.8 / 56.3 Amps

•

Recommended Circuit Breaker – 50 Amps

•

Always consult local and national electric codes.

•

Countertop MUST be level in all directions and adjustable range 
height at least 1/16" greater than tallest cabinet height, to ensure metal
rangetop flange will fit properly on countertop edge.

•

When installing optional Backguard Kit, cutout depth of 21-3/4" 
minimum / 22-1/8" maximum needs increased to 24".

•

Overhead cabinetry should not exceed a 13" maximum depth.

•

Absolute minimum horizontal distance between overhead cabinets
installed to either side of appliance must be no less than maximum width
of appliance.

•

Allow 24" minimum clearance between rangetop and bottom of cabinet
when bottom of wood or metal cabinet is protected by not less than 1/4"
flame-retardant millboard covered with not less than No. 28 MGS sheet
steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper. Allow
30" minimum clearance when cabinet is unprotected.

•

To reduce risk of fire when using overhead cabinetry, install range hood
that projects horizontally a recommended minimum of 5" beyond bottom
of cabinets.

•

When installing range into existing cutout depth greater than 22-1/8",
optional 2" Rear Filler Kit available.

For detailed preparation instructions, refer to installation guide on the web.

•

Flat square-finish (flat) countertop requires no preparation since rangetop
flange lays directly on countertop edge. 

•

Formed front-edged countertops require front molded edge to be shaved
flat 3/4" from each front corner of opening. 

•

Tile countertops may need cut back 3/4" from each front corner of
opening and / or rounded edge flattened. 

•

For existing cutout width greater than 30-1/16" reduce the 3/4" overlap
dimension or for cutout width of 29", replace actual side trim panels with
smaller side trim panels, available with optional Side Trim Kit (refer to
detailed kit installation instructions).

•

Grill / Griddle – (PN # 318251611).

•

2" Rear Filler Kit: S – (PN # 903113-901S).

•

Side Panel Kit: S – (PN # 903102-901S).

•

Backguard Kit: S – (PN # 903111-901S).

•

Side Trim Kit: S – (PN # 903110-901S).