Electrolux EIMED60JIW 仕様シート

Electric Front Load Dryers

• 

Product Weight – 130 Lbs.

• 

Voltage Rating – 240V / 60 Hz / 30 Amps

• 

Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical 

supply with ground required on separate circuit fused on both sides of 

line. (Do not use same circuit as washer.)

• 

Connected Load (kW Rating) @ 240 Volts = 6.0 kW

• 

Amps @ 240 Volts = 25 Amps

• 

Dryer MUST employ a 3-conductor NEMA 10-30 type SRDT or 

4-conductor NEMA 14-30 type SRDT or ST (as required), rated at 240 

volt AC minimum, 30 amp power supply cord marked for use with clothes 

dryers (not supplied).

• 

Grounding through neutral link prohibited in specific applications and 

certain locales, requiring use of 4-wire system. (For detailed electrical 

• 

Always consult local and national electric & plumbing codes.

• 

Can be installed alone, with or without optional 15" pedestal drawer, or 

stacked above matching Electrolux Washer, which requires installation 

of optional dryer stacking kit. (For installation details, refer to instructions 

• 

Can be built in with matching Electrolux Washer in under-counter, 

recessed or closet installation. Installations requiring countertop and / or 

cabinetry will require custom building. (Refer to Built-In Installations on 

• 

Closet installation requires vented door with 2 unobstructed louvered 

openings, minimum 60 sq. in. each, located 3" from top and bottom of 

door. Full-length 120 sq. in. opening also acceptable. Allow 1" clearance 

between door and fronts of units.

• 

Do NOT install in area exposed to dripping water or outdoor weather 

conditions, or where gasoline or other flammables, including automobiles, 

are kept or stored.

• 

Floor MUST be solid with 1" maximum slope. To ensure vibration or 

movement does not occur, reinforcement of floor may be necessary. Do 

NOT install on carpeted surface.

• 

Dryer MUST exhaust to outside of building, NOT into any concealed space.

• 

Dryer equipped for 4-way venting and approved for up to 125-foot-

equivalent of duct length, determined by length of run and number of 

elbows needed.

• 

Exhaust installation requires minimum 4"-diameter rigid or semi-rigid metal 

duct with approved, unobstructed vent hood having swing-out damper(s). 

If installing rigid metal duct (preferred), do not exceed MAXIMUM venting 

run length of 125 ft., allow deductions for elbows and vents. If installing 

semi-rigid metal duct, do not exceed MAXIMUM venting run length of 8 ft., 

always allow deductions for elbows and vents (Refer to Product Installation 

. Do NOT use flexible plastic or 

metal foil duct and use shortest run possible.

• 

Leveling legs supplied to level dryer properly and reduce excessive noise 

and vibration.

• 

Water inlet hose for steam setting connects to cold water supply with “Y” 

connector and requires 3/4" clearance between back of unit and wall.

• 

Pedestal Drawers –  Silver Sands (PN # EPWD15SS),  

Titanium (PN # EPWD15T), Island White (PN # EPWD15IW).

• 

Dryer Stacking Kit – (PN # STACKIT4X).

• 

Mobile Home Installation Kit – (PN # 137067200).

• 

Drying Rack – (PN# 137453000).