Electrolux E36GF76JPS オーナーマニュアル

• Boilovers have cooked onto surface. Use razor blade scraper to remove soil. See 

instructions under

 general Care & Cleaning. 

• Cleaning materials not recommended for ceramic-glass cooktop have been used. Use 

recommended cleaners and cleaning method. See 

Ceramic-Glass Cooktop section in 

this Owner’s Guide.

• Mineral deposits from water and food. Wet surface with water and sprinkle on a cooktop 

cleaning creme. Scrub with a clean damp paper towel until the stain disappears. Wipe 

remaining paste away, then apply a small amount of cooktop cleaning creme and polish 

with a clean paper towel. Use cookware with clean, dry bottoms. See 

Cooktop section in this Owner’s Guide.

• Place oven rack in center of oven. Place a level on the oven rack. Contact installing 

agent if rack and cabinet cutout flooring are not level.

• Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets 

are square and level. Contact cabinet maker to correct problem.

• Many factors affect baking results. See 

Baking for hints, causes and corrections.

• When the unit is first plugged in, or when the power supply to the range has been 

interrupted, the indicator lights will flash and the control will beep. To stop the lights from 

flashing, turn the selector control knob to BAKE and back to OFF. The oven cannot be 

used until this step is followed.

• Be sure electrical cord is securely connected into the electrical junction box.

• Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact a 

qualified servicer. 

• Service wiring not complete. Contact a qualified servicer. 

• Power outage. Check house lights to be sure. Call your local electric company.

• Short in cord/plug. Replace cord/plug.

• Controls are not set properly. See instructions under 

Setting Oven Controls to set the 

controls.

• House fuse has blown or circuit breaker has tripped immediately following installation. 

House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker 

securely.

• House fuse has blown or circuit breaker  has tripped after the oven has been installed 

and previously operating. Contact a qualified servicer.