Electrolux EW26SS85KS オーナーマニュアル

Your refrigerator’s water supply system 

includes several tubing lines, an advanced 

water filter, a distribution valve bank, and a 

reserve tank to ensure ample supply to the ice 

and water dispenser at all times. This system 

needs to be completely filled with water when 

first connected to an external supply line.

  1  Begin filling the tank by pressing and 

holding a drinking glass against the 

water dispenser paddle.

  2  Keep the glass in this position until water 

comes out of the dispenser. 

  3  Continue dispensing water for about 

three minutes to flush the system and 

plumbing connections of any impurities 

(stopping to empty the glass as 

necessary).

The ice maker, ice bin, and dispenser feeding 

mechanism are located in the top of the 

freezer compartment. After the refrigerator is 

installed properly and has cooled for several 

hours, the ice maker can produce ice within 

24 hours. It can completely fill an ice bin in 

about two days.
The ice maker produces four to six pounds 

of ice every 24 hours depending on usage 

conditions. Ice is produced at a rate of eight 

cubes every 75 to 90 minutes.

Before making ice for the first time, be sure 

to prime the water supply system. Air in new 

plumbing lines can result in two or three 

empty ice maker cycles. Furthermore, if the 

system is not flushed, the first ice cubes may 

be discolored or have an odd flavor.

Wire

Signal Arm

Your ice maker is turned on at the factory 

so it can work as soon as you install your 

refrigerator. If you cannot connect a water 

supply, turn the ice maker’s 

On/Off switch 

to Off. Otherwise, the ice maker’s fill valve 

may make a loud chattering noise when it 

attempts to operate without water.

For proper dispenser operation, 

recommended water supply pressure 

should fall between 30 psi and 100 psi. 

Excessive pressure may cause water 

filter to malfunction.

The ice maker also has a built-in wire 

signal arm, which automatically stops ice 

production when the ice bin is full. This 

signal arm should not be used to manually 

stop the ice maker.

The water dispenser has a built-in device 

that shuts off the water flow after three 

minutes of continuous use. To reset this 

shutoff device, simply release the dispenser 

paddle.

Ice production is controlled by the ice maker’s  

On/Off power switch. To gain access to 

the ice maker, pull the extra shelf out (some 

models). Press the switch to the “

O” position 

to turn it Off and press to the “

I” position to 

turn it On.