Electrolux EI23CS65KS オーナーマニュアル

ページ / 45
5
This Use & Care Guide provides general 
operating instructions for your model. Use the 
refrigerator only as instructed in this Use & 
Care Guide. 
Before starting the refrigerator, 
follow these important first steps.
Location
•  Choose a place that is near a grounded 
electrical outlet. 
Do Not use an 
extension cord or an adapter plug.
•  If possible, place the refrigerator out of 
direct sunlight and away from the range, 
dishwasher or other heat sources.
•  The refrigerator must be installed on a 
floor that is level and strong enough to 
support a fully loaded refrigerator.
•  Consider water supply availability for 
models equipped with an automatic ice 
maker.
Installation
Installation clearances
•  Allow the following clearances for ease 
of installation, proper air circulation, and 
plumbing and electrical connections:
 
Sides & Top 
⅜ inch
 Back 
 1 
inch
Door opening
Installation
CAUTION
DO NOT install the refrigerator where 
the temperature will drop below 55°F 
(13°C) or rise above 110°F (43°C). 
The compressor will not be able to 
maintain proper temperatures inside the 
refrigerator.
DO NOT block the toe grille on the lower 
front of your refrigerator. Sufficient air 
circulation is essential for the proper 
operation of your refrigerator.
NOTE
If your refrigerator is placed with the door 
hinge side against a wall, you may have to 
allow additional space so the door can be 
opened wider.
To remove toe grille
  1  With both doors closed, unfasten right 
and left side clips of toe grille from 
bottom hinge groove.
  2  Open both doors. Press firmly on top of 
toe grille until top of toe grille pops off.
  3  Pull toe grille outward towards your body 
and off of lower hinges.
1
2
3 2
3
1
Removing Toe Grille
4
4
5
5
Installing Toe Grille
4
5
Toe Grille Installation and Removal
To install toe grille
  1  Open both doors. Slide left and right 
sides of toe grille over lower hinges of 
refrigerator.
  4  Close the doors. Fasten right and left side 
of clips into groove of bottom hinge by 
pulling outwards on the edge.
  5  Ensure the triangle flap is resting on top 
of the door hinge.
  2  While pushing toe grille firmly against 
cabinet, fasten bottom clips of toe grille 
to cabinet.
  3  Fasten top clips to cabinet.