Electrolux E15IM60GSS オーナーマニュアル

Door Adjustment

4     If door edge opposite the hinges needs to 

move up, move plate toward outside of door. 
If door edge needs to move down, move 
plate toward inside of door (see Figure 22). 
Repeat until top edge of door is parallel with 
top of cabinet and tighten screws securely.

Your door is aligned at the factory before shipment. 
Occasional re-adjustment may be necessary, 
especially if an overlay panel is installed. The 
following procedure will correct for up to 1/4” 
alignment.

The door should never be flush with the top of the 
cabinet. Even when level, the top edge of the door 
will be 1/8” below the top of the cabinet (see Figure 
20).

To adjust :
1    Compare the top edge of the door (opposite 

the hinges) to the top edge of the cabinet 
and note the type of adjustment (up or down) 
needed.

2     Remove the top hinge pivot pin with a 

Phillips

®

 head screwdriver (see Figure 21) 

and lift door off bottom hinge pin. Be careful 
not to lose door closers (see Figure 23).

3    With door upside-down, loosen but do not 

remove the two hinge plate screws.

CLRCO001a

UL312

5     After adjustment is complete, remove the 

door closers from the bottom hinge, clean 
thoroughly and apply petroleum jelly to the 
mating surfaces of  the closers (see Figure 
23). Be sure that bosses on closers align with 
holes in hinge and hinge plate. Mount door 
and install top hinge pivot pin.