Electrolux E15IM60GSS オーナーマニュアル

Water Supply Connection

When connecting the water supply, follow these 
guidelines:

•     Review the local plumbing codes before you 

install the unit.

•     The water pressure should be between 30 

and 120 psi.

•     Make certain a SHUT-OFF VALVE is installed 

in the 1/4 inch water supply line.

•     Connect sufficient tubing to the unit to 

allow the unit to be moved for cleaning and 
servicing. However, make certain that the 
tubing is not pinched or damaged during 
installation.

•     Electrolux recommends the use of copper 

tubing for installation. 

DO NOT use plastic 

water supply line since it may crack or 
rupture with age and may cause water 
damage to your house.

1     Locate the compression fitting and ferrule 

packed in the unit. Slide the compression 
fitting and ferrule over the 1/4 inch water 
supply line. Do not use thread sealing 
compound or tape. Using two wrenches, 
tighten the compression fitting on the supply 
line (see Figure 6).

2     Carefully bend the water supply line into 

position and connect the line to the solenoid 
valve. Avoid kinking the water supply line.

3     For recessed installations, allow extra water 

supply line length to provide slack for easy 
removal from the recessed area (see Figure 
8). This will also safeguard against kinking 
the line.

4    Plug in the power cord.
5     Gently push the unit into position. If desired 

the unit may be recessed into cabinet or wall.

6     Allow at least 1-1/2 inches clearance behind 

the unit for electrical, water supply and drain 
connections.

UL103_CO

UL134