Electrolux E30IC80ISS 仕様シート

ページ / 4
Electric Cooktop Installation 
Over 30"Electric Single Wall Oven
High standards of quality at Electrolux Home Products, Inc. mean we are 
constantly working to improve our products. We reserve the right to change 
specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA
10200 David Taylor Drive 
Charlotte, NC 28262 
1-877-4electrolux (1-877-435-3287) 
electroluxicon.com
CANADA
5855 Terry Fox Way 
Mississauga, ON L5V 3E4 
1-800-265-8352 
electroluxicon.ca
EC_EW INST  03/12
© 2012 Electrolux Home Products, Inc.
30" Electric Single Wall Oven Under-Counter 
Installation Specifications
Product Weights – (E30EW75GPS) 178 Lbs. / (E30EW75GSS) 177 Lbs.
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz 
AC only electrical supply with ground required on separate circuit fused
on both sides of line.
Connected Load (kW Rating) @ 240 / 208 Volts = 4.0 / 3.0 kW
Amps @ 240 / 208 Volts = 16.7 / 14.4 Amps
Always consult local and national electric codes.
Minimum 23-1/4" clearance for oven door depth when open.
Minimum 24" deep cutout dimension is critical for proper installation, 
to ensure that oven’s faceplate will fit flush against cabinet front.
Full oven base of solid plywood or similar material required, capable 
of supporting 200 Lbs. Install over two runners and flush with toe plate.
Base must be level and cabinet front must be square with finish-cut
bottom edge.
Side filler panels necessary to isolate oven from adjoining cabinets.
Allow 5" maximum height from oven base to floor, if NO cooktop is
installed directly over wall oven.
Electric Cooktop Installation Over 
30" Electric Single Wall Oven Specifications
Electrolux ICON
®
Single Wall Oven models E30EW75GPS and
E30EW75GSS are approved to be used beneath Electrolux ICON
®
electric cooktop models E36IC80ISS, E30IC80ISS, E36EC70FSS and
E30EC70FSS (electric cooktop models NOT approved for use in this
installation are E36EC75HSS, E30EC65ESS and E36EC65ESS)
.
For detailed Electric Cooktop installation, refer to model-specific 
product page and installation guide on web.
Side filler panels necessary to isolate oven from adjoining cabinets. 
Panel height may need to be modified to accommodate the depth of
approved electric cooktop models.
To route armored cable to junction box, cut minimum 4" x 4" opening 
in right cabinet side panel.
Allow 4-1/2" maximum height from oven base to floor, if cooktop is
installed directly over wall oven.
Note: For planning purposes only. Refer to Product Installation Guide 
on the web at electroluxicon.com for detailed instructions.