Electrolux EW30IS65JS インストール手順

12

1.  Draw a center line (CL) on the floor where the range 

should be installed. Also draw a line on the floor at 
the range back position if there is no wall.

2.  Unfold paper template and place it flat on the floor 

with the right rear corner positioned exactly on the 
intersection of the center and back lines you just drew 
before. (Use the diagram below to locate brackets if 
template is not available. (Figure 11))

3.  Mark on the floor (or wall) the location of the 

mounting holes shown on the template. For easier 
installation, 3/16"(0,48 cm) diameter pilot holes 
1/2"(1,27 cm) deep can be drilled into the floor (or 
wall).

4.  Remove template and place bracket on floor. Line up 

holes in bracket with marks on floor/wall and attach 
with screws provided. Bracket must be secured to solid 
floor or wall (Figure 12). If attaching to concrete floor, 
first drill 3/16"(0,48 cm) dia. pilot holes using masonry 
drill bit.

5.  Be sure the 4 levelling legs are at the highest position 

they can be.

6.  Slide range into place making sure structure of the 

range is trapped by the anti-tip bracket (Figure 11). 
Lower the range by adjusting the 4 levelling legs until 
the underside of the cooktop is sitting level on the 
countertop. Refer to “Levelling the Range” section.

7.  After installation, verify that the anti-tip bracket is 

engaged by grasping the top rear edge of the range 
and carefully attempt to tilt it forward to make sure 
range is properly anchored.

 To reduce the risk of tipping of the 

range, the range must be secured to the floor by properly 
installed anti-tip bracket and screws packed with the 
range. These parts are located in the oven. Failure to 
install the anti-tip bracket will allow the range to tip over 
if excessive weight is placed on an open door or if a child 
climbs upon it. Serious injury might result from spilled hot 
liquids or from the range itself.
Follow the instructions below to install the anti-tip 
brackets.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the 
range.
Tools Required:
Adjustable Wrench
Ratchet
Drill & 1/8"(0,32 cm) bit
5/16" (0,8 cm) Nutdriver
Level

The anti-tip bracket attaches to the floor (or back wall) 
at the back of the range to prevent range from tipping. 
When fastening bracket to the floor, be sure that screws 
do not penetrate electrical wiring or plumbing. The screws 
provided will work in either wood or concrete.

Range

Anti-Tip Bracket

Floor Mount

Rear of Range

Wall

Mount

BACK EDGE OF
RANGE LINE OR

REAR 

WALL

REAR 

WALL

ANTI-TIP

BRACKET

CL

10    ”

¼

(26.04 cm)

Toe

Plate

Door

Cabinet

Kitchen

Cabinet

SLIDE

BACK