Electrolux E24RD75HSS 配線リファレンス

ページ / 2
service data sheet
242007200
reFriGeratOr draWers - r134a 
impOrtant saFety nOte
The information provided herein is designed to assist qualified repair 
personnel only. Untrained persons should not attempt to make repairs 
due to the possibility of electrical shock. Disconnect power cord before 
servicing this appliance.
impOrtant
If any green grounding wires are removed during servicing, they must 
be returned to their original position and properly secured.
 
cautiOn
all electrical parts and wiring must be shielded from torch flame. 
dO  nOt  allow  torch  to  touch  insulation;  it  will  char  at  200°F 
and flash ignite (burn) at 500°F. excessive heat will distort the 
plastic liner.
PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS 
AT MID-POINT CONTROL SETTING
type a with run/start           
capacitor
65°F (18°c) ambient
90°F (32°c) ambient
Operating Time
N/A
30 to 50%
Temperature
34º F to 45º F
34º F to 45º F
Low Side Pressure      
(cut-in)
30 to 45 psig
208 to 310 kPa
30 to 45 psig
208 to 310 kPa
Low Side Pressure      
(cut-out)
-2 to 4 psig
-14 to 28 kPa
-2 to 4 psig
-14 to 28 kPa
High Side Pressure               
(last 1/3 cycle)
90 to 120 psig
621 to 827 kPa
130 to 175 psig
896 to 1207 kPa
Wattage (last 1/3 cycle)
85 to 125
85 to 125
Amps (running)
.75 to 1.2
.75 to 1.2
Base Voltage
115 vac (127 vac max)
cOndenser Fan mOtOr
Watts
rpm
amps
3.1
1100 CW Opposite 
Shaft
0.03 Running
evapOratOr Fan mOtOr
1.7 each
9000
.02 each
2.75”
 
icOn
tm 
unit dimensions
Model
Width 
Height
Depth
Designer
23
13
/
16
 inch
34-35 inches
26
3
/
4
 inch
Professional
23
13
/
16
 inch
34-35 inches
26
3
/
4
 inch
nOte
Your Electrolux refrigerator drawers has been designed for built-
in installation.  Your refrigerator drawers do not require additional 
air space for top, sides or rear.  The front grille must 
nOt be 
obstructed.
To ease unit installation and removal, it is recommended that the 
cabinet rough opening dimensions be increased by at least ¼ inch 
over the dimensions given for your unit.
impOrtant: pLease return this sheet tO it’s 
OriGinaL LOcatiOn.
      
 WarninG
double drawer refrigerator drawers are designed to be built-
in only. they can not be used for free-standing.
all screws supplied with the anti-tip Kit are for mounting 
the bracket directly to wall studs. these screws will not work 
if used with sheetrock (dry wall) or anything other than wall 
studs.
2.75”
3.25”
icOn
tm
designer
icOn
tm
professional