Electrolux E24RD50QS オーナーマニュアル

10

Adjusting the temperature:
To set or check the set-point temperature 

(with the control out of sleep mode), 

press the "-" or "+" keypads. "SET" will 

be indicated on the user interface panel 

and the current set-point temperature will 

display and flash. Subsequent presses 

of the "-" or "+" keypads will adjust the 

temperature colder or warmer respectively. 

When you have reached your desired 

set-point temperature, press the "On/Off" 

keypad to accept, or do nothing and the 

"Set" mode will time-out in 10 seconds 

accepting the displayed temperature as 

the new set-point.
The available set-point temperature range 

for your appliance is 34°F (1.1°C) to 

42°F (5.6°C). If you attempt to adjust the 

temperature outside of this range you will 

receive an audible notification.
When initially loading your product with 

warm contents, it may take up to 48 hours 

for the storage compartment temperature 

to stabilize.
When making temperature set-point 

changes, it may take up to 24 hours for 

the stored contents to stabilize at your 

new set-point temperature.

•  Changes to temperature setting.
•  Room temperature changes.
•  Temperature of stored contents.

 

-  Loading warm contents.

 

-  Cold content load will delay the 

change to a warmer set-point 

temperature.

 

-  Warm content load will delay 

the change to a colder set-point 

temperature. 

•  Usage, (number and duration of the 

drawer openings).

•  Use of the storage compartment 

display lighting.

•  Installation of the appliance in direct 

sunlight or next to a heat source.

Temperature mode:
The temperature mode is preset from the 

factory in Fahrenheit (°F) but you have the 

option to change it to Centigrade (°C). To 

change the mode, press and hold the "-" 

keypad, while pressing the "+" keypad, 

then release the "-" keypad.
The temperature will now be displayed in 

Centigrade (°C).
Repeat the procedure to change the 

temperature mode back to Fahrenheit (°F).

Control lock:
The control panel can be locked to avoid 

unintentional changes. To lock the control, 

press and hold the "Lock" keypad until the 

display reads "Loc". The lock icon will flash 

3 times and then continuously illuminate. 

When the control panel is locked, only the 

Lock keypad, System Status OK indicator, 

and the Alarm indicator are active. To 

unlock the control panel, repeat this 

instruction until the display reads "nLc".

Operation