Electrolux E30MO65GSS インストール手順
4
CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS
MODEL AND SERIAL NUMBER LOCATION
The serial plate is located on the oven faceplate.
When ordering parts for or making inquires about your oven,
always be sure to include the model and serial numbers and
a lot number or letter from the serial plate on your oven.
always be sure to include the model and serial numbers and
a lot number or letter from the serial plate on your oven.
CABINET INSTALLATION
1. Place oven on the Bottom Duct Assembly. Adjust the
position of the feet of the oven so that they are fitted
into the recesses of the Bottom Duct Assembly. Place
assembled unit adjacent to the wall or cabinet opening.
Plug the power cord into the electrical outlet.
into the recesses of the Bottom Duct Assembly. Place
assembled unit adjacent to the wall or cabinet opening.
Plug the power cord into the electrical outlet.
2. Carefully guide the oven with the Bottom Duct Assembly
Illustration 5
Illustration 6
FRAME INSTALLATION
Locate tabs on the built in trim kit to the slots on control
panel and slide the built in trim kit to the left to lock the tabs
in place.
panel and slide the built in trim kit to the left to lock the tabs
in place.
in the the prepared opening. See illustration 5. Avoid
pinching the cord between the oven and the wall. When
the Bottom Duct Assembly is in the opening correctly,
the flange will be tightly against the lower edge of the
opening. Secure the Bottom Duct Assembly with the two
(1 ³⁄₁₆") SCREWS (C). See illustration 6.
pinching the cord between the oven and the wall. When
the Bottom Duct Assembly is in the opening correctly,
the flange will be tightly against the lower edge of the
opening. Secure the Bottom Duct Assembly with the two
(1 ³⁄₁₆") SCREWS (C). See illustration 6.
Position and attach the built-in trim kit frame with 4
screws (B) to the cabinet. See illustrations below.
screws (B) to the cabinet. See illustrations below.
BEFORE YOU CALL FOR SERVICE
Refer to the warranty in your Use & Care Guide for our toll-free
service number and address. Please call or write if you have
inquiries about your product and/or need to order parts.
service number and address. Please call or write if you have
inquiries about your product and/or need to order parts.
Slide trim kit to the left to lock
into place. There should be no
gap between the trim kit and
the microwave.
into place. There should be no
gap between the trim kit and
the microwave.
3
No gap
should
be visible.
should
be visible.
Insert two tabs on right side
of trim kit into the slots on the
microwave control panel.
of trim kit into the slots on the
microwave control panel.
1
Swing trim kit until it rests
against cabinet.
against cabinet.
2
Screw trim kit to cabinet
using 4 screw (B)'s.
using 4 screw (B)'s.
4
SCREW B
Pre-drill 56 " hole
SCREW B
SCREW B
SCREW B
BOTTOM DUCT
ASSEMBLY
FOOT
DUCT RECESS
SCREW C
DETAIL A
SCREW C