Electrolux E30MO65GSS 仕様シート
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA
•
250 Bobby Jones Expressway
•
Augusta, GA 30907
•
1-877-4electrolux (1-877-435-3287)
•
electroluxicon.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
electroluxicon.ca
E30MO65GSS 12/13
© 2013 Electrolux Major Appliances, NA
30" Built-In Convection Microwave Specifications
•
Product Weight – 60 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.55 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire service
with a separate ground wire. Appliance must be grounded
for safe operation.)
•
Amps @ 120 Volts = 13 Amps
•
Always consult local and national electric codes.
•
Allow 19" minimum clearance for 90° door swing.
•
Built-In installation requires use of 30" Trim Kit (PN # E30MO65TMK)
which is supplied and includes Stainless Steel Faceplate, Exhaust
Duct Assembly and Bottom Duct Assembly – shipped in separate box.
•
Minimum 20-1/8" deep oven cutout dimension is critical for proper
installation for oven and faceplate to fit flush against cabinet front.
•
Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
•
Base must be level and front of cabinet square for proper operation.
•
Grounded outlet should NOT be located in shaded area, as indicated.
•
Can NOT be installed above any gas wall oven.
•
Built-In Microwave is NOT approved to be used under counter.
•
Built-In Convection Microwave can be built in alone or is approved to
be used in combination with any Electrolux ICON
®
Electric Single
Wall Oven and / or Warmer Drawer. (Refer to model-specific Combination
Installation Specifications pages on web.)
•
When used in combination with another Electrolux ICON
®
built-in
product, a minimum clearance of 3-1/8" required from bottom of Built-In
Microwave cutout to top edge of companion product’s faceplate, leaving
a 2" visible gap between both product faceplates.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
Built-In Microwave with 30" Trim Kit
E30MO65GSS
Built-In Convection Microwave
E30MO65GSS designer series