Electrolux EW30GS80RS インストール手順

H1

H2

H3

H4

1.  The counter-top around the cut-out should be flat and leveled 

(see hatched area on illustration 1).

2.  Before installing the unit, measure the heights of the two (2) 

cabinet sides (H1-4), front and back (see illustration 1) from the 

floor to the top of the counter.

Illustration 1

Shave Raised Edge 

to Clear Space for a 

31½" (80 cm) Wide 

Cooktop.

1 ½" Max.

(3.8 cm Max.)

Illustration 2

To successfully 

install the 

range, the initial 

level height 

from floor to 

underside of 

cooktop frame 

should be at 

least 1/16" (0,16 

cm) taller than 

cabinet sides 

as measured in 

step 2.

8.  After the installation, MAKE SURE that the 

unit is supported by the two front leveling 

Metal Flange

3.  Level the range using the leveling legs 

and the adjustable leveling wheel (If 

equipped), so that the height from 

the floor to the underside of the 

metal flange is greater than the tallest 

cabinet measurement by at least 

1/16" (0,16 cm) (see illustration 2).

4.  Model equipped with leveling device: Remove and discard the 

two rear leveling legs, they are only in place to solidify the unit for 

the transport.

5.  Slide the unit into the cabinet. Make sure the center of the unit is 

aligned with the center of the cabinet cut-out.

6.  Remove the protective channels on each side of the cooktop (if 

provided).

7.  The metal flange under each side of the cooktop MUST be 

placed over the cabinet countertop for proper unit support. 

The cooktop should NOT rest directly on the countertop (see 

illustration 2) or else it could cause damage to the cooktop 

voiding the warranty. Level the unit if needed.

legs and the 

two adjustable 

leveling wheels 

and NOT by the 

cooktop.