Electrolux EP19WI30LS オーナーマニュアル
20
Preventing Damage from Freezing-3
For EN19WI30LS, EP19WI30LS
Drain Plugs
Each drain plug might not be visible if
insulation is installed around the piping.
insulation is installed around the piping.
If the water heater will not be used for a long period of time, drain the water.
Drain the water as follows:
To avoid burns, wait until the equipment cools down
before draining the water. The appliance will remain
hot after it is turned off.
before draining the water. The appliance will remain
hot after it is turned off.
High Temperature
CAUTION
Fully open all hot water fixtures.
4
Open all drain plugs and drain the water out of
the unit.
the unit.
1
Close the water supply
valve.
valve.
6
Close the gas valve and disconnect
the electrical power supplied to the unit.
the electrical power supplied to the unit.
2
3
Fully open all
hot water fixtures.
hot water fixtures.
Fixture
Drainage Using the Remote Controller
2
5VSOUIFQPXFSPOPGGCVUUPOi0Ou
(2) Turn and leave open
the hot water fixtures
for more than 2 minutes
and
close.
* If multiple units are being used,
drain two minutes for each unit.
* An 11 Error Code may appear on
the remote controller.
This is not a malfunction of the unit.
%POPUUVSO1PXFS0/0''#VUUPO0''
%POPUUVSO1PXFS0/0''#VUUPO0''
Manual Draining
Close the water supply
valve and disconnect
the electrical power
supplied to the unit.
valve and disconnect
the electrical power
supplied to the unit.
3
4
5
When the water is completely drained, replace
all drain plugs and close the hot water fixtures.
all drain plugs and close the hot water fixtures.
5
Open all drain plugs and drain the
water out of the unit.
water out of the unit.
6
Close the gas valve.
1
W h e n t h e w a t e r i s c o m p l e t e l y
drained, replace all drain plugs and
close the hot water fixtures.
drained, replace all drain plugs and
close the hot water fixtures.
Fixture
Fixture
(Ex. 120°F)
Do not touch with wet hands.
Do not touch with wet hands.
Drain water into a bucket to prevent water damage.
5VSOUIFQPXFSPOPGG
CVUUPOiPGGu
(2) Press the flow meter alarm set
button for about two seconds
until the alarm sounds.
until the alarm sounds.
The maximum hot water
temperature will flash.
temperature will flash.
(3) Press the flow meter alarm
set button again.
(4) Press the setting button
NBSLFEiu. The display will
DIBOHFGSPNP'UPPOBGUFS
the button is pushed.
DIBOHFGSPNP'UPPOBGUFS
the button is pushed.