Electrolux EP19WI30LS オーナーマニュアル

ページ / 38
6
Important Safety Information
-
3
CAUTION
Do not drink water that has been inside the 
unit for an extended period of time. Do not 
ESJOLUIFmSTUVTFPGIPUXBUFSGSPNUIF
unit in the morning.
$MFBOUIFmMUFSPOUIFXBUFSJOMFUBT
frequently as required by the quality of  
your local water.
Keep the area around the unit clean.
If boxes, weeds, cobwebs, cockroaches etc. are in 
the vicinity of the unit, damage or fire can result.
Do not install the equipment where the 
exhaust will blow on walls or windows.
Problems resulting from scale formation 
are not covered by the warranty.
This unit is only approved for installation 
up to 4500 ft. (1350m) above sea level.
For installations at higher elevations, contact 
Electrolux Home Products, Inc. for Instructions.
Check ignition during use and extinction 
after use.
If the water supply is in excess of 12 grains 
per gallon (200 mg/L) of hardness, acidic 
or otherwise impure, treat the water with 
approved methods in order to ensure full 
warranty coverage.
Preventing damage from freezing (
p.18)
Damage can occur from frozen water within the 
device and pipes even in warm environments.  
Be sure to read below for appropriate measures.
Repairs for damage caused by freezing are not 
covered by the warranty.
Take necessary measures to prevent 
freezing of water and leakage of gas when 
leaving the unit unused for long periods of 
time. (
p.19, 20)
%POPUVTFQBSUTPUIFSUIBOUIPTFTQFDJmFE
for this equipment.
If it is snowing, check the exhaust vent 
terminal for blockage.
Do not disassemble the remote controller.
Do not use benzene, oil or fat detergents  
to clean the remote controller.
This may cause deformation.
Do not get the remote controller wet.
Although it is water resistant, too much water can 
cause damage.
Do not splash water on the remote 
controller. Do not expose the remote 
controller to steam.
Do not locate the remote controller near stoves or 
ovens, this may cause damage or failure.
Do not run water through the unit when 
unit is not on.
When discharging hot water, make sure the unit is ON.
If water is run through the unit with the unit
OFF, water may condense inside the unit and cause 
incomplete combustion or damage to the internal 
electrical components.
For single-handle fixtures or valves, discharge
water setting the handle completely
to the water side.