Electrolux UR15IM20RS オーナーマニュアル

16 Built-In Installation/Start-Up

Your ice machine comes with an optional 

"ECO" mode. While in this mode ice 

production will slow and the appliance 

will use less water and electricity. "ECO" 

mode should only be used after there is a 

full bin of ice. To enter "ECO" mode do the 

following:

•  Press the "MENU" icon twice 

and the green "ECO" will flash.

•  Press and hold the "ON/OFF" 

icon until the green "ECO" stops 

flashing and remains illuminated.

•  To return to the standard 

operating rate press the "MENU" 

icon twice, the ECO will turn off 

and the "ICE" will be flashing. Press 

and hold the "ON/OFF" icon until 

the "ICE" stops flashing and 

remains illuminated.

To clean your ice machine you will need 

to purchase a "nickel safe" ice maker 

cleaner. Cleaner is available at most 

appliance retailers or through the cleaners 

website. Several recommended cleaners 

are listed below:

•  Kirby's Certified ice machine cleaner. 

100% nickel safe.

•  Nu-Calgon nickel safe ice machine 

cleaner.

•  Franklin Machine Products Nickel 

safe ice machine cleaner.

If the door is open, or not closed 

properly for 5 minutes the "DOOR" 

indicator will illuminate and flash and 

an audible tone will sound. This alarm 

condition can be reset by closing the 

door or momentarily pressing the "ON/

OFF" icon, (i.e.-if you are cleaning the 

storage compartment, etc.). The alarm will 

recur in 5 minutes if the alarm condition 

persists.
If the door is intentionally left open for long 

periods, the alarm can be disabled by 

turning the unit off. 

Figure 1

Remove the

grid cutter 

cover

Remove all

of the ice

from the 

ice bin

Forcing ice through the grid cutter 

will break the grid cutter wires.

Figure 2

Figure 3

Remove all ice from

the evaporator plate

and grid cutter area

that is not embedded

in wires

Allow all of the ice to fall from the 

evaporator plate and remove any ice from 

the grid cutter. If there is ice embedded in 

the grid cutter wires, wait for it to melt and 

fall out. Do not try to remove ice that is 

embedded in the grid cutter wires as that 

may break the wires (Figures 2 and 3).

Turn the ice machine off by pressing 

and holding the "ON/OFF" icon for 

3 seconds. "OFF" will be displayed 

on the control.
Remove the grid cutter cover (Figure 1) 

by pulling the cover off of the three rubber 

isolation mounts.
Remove all ice from the ice bin (Figure 1).