Electrolux UR15IM20RS オーナーマニュアル

23

  1.  Unplug the ice machine from the 

electrical supply and remove the rear 

access cover from the ice machine. 

  2.  Unscrew the leveling leg in the back 

corner until the end of the threaded 

portion is flush with the threaded nut 

insert in the base (Figure 8). 

  3.  Unscrew the 3 hose clamps and 

remove the 3 hoses from the front of 

the drain pump and remove retaining 

brackets (Figure 8).

  4.  Rotate the drain pump and remove 

from the ice machine (Figure 7). It 

may be necessary to disconnect the 

ground wire connection in the back 

flange of the cabinet (Figure 8).

Figure 8

Unscrew the leveling

leg so the end of the 

threads is flush with 

the top of the nut inset.

Drain pump

ground wire

connection

Remove these 3 

hose clamps, then 

remove the 3 tubes 

from the drain pump

Figure 7

Rotate drain pump and remove from

back of ice machine.

Drain valve

  1.  The drain pump must be level.
  2.  No pinched water lines.
  3.  No interference with electrical cords 

or wiring.

  4.  The drain pump should not set on 

any obstacles, wiring, etc.

  5.  Secure all hose clamps leading to 

and from the drain pump.

  6.  Ensure that the vent tube height is 

adequate - 18 inch minimum.

  7.  Ensure that drain height is adequate - 

maximum of 8 foot.

  8.  Ensure that drain length is adequate - 

maximum of 20 foot.

  9.  Checked for water leaks after 

installation of the drain pump.

 10.  Check for vibrations caused by 

improper installation.

 11.  Ensure that there is no interference 

with back access cover.

 12.  Ensure that the hole grommets are 

in place at each location so that any 

vent or drain tubes do not rub on any 

sharp surfaces.

Figure 9

Ice Machine

Power Cord

  5.  Disconnect the ice machine power cord 

from the drain pump (Figure 9).

  6.  Drain the water in the drain pump’s 

reservoir by turning the pump upside 

down and allowing water to drain 

through the pump’s inlet and vent 

tube fittings.

  7.  Installation of drain pump is reverse 

of this procedure.