Electrolux UL15IM20RS オーナーマニュアル

11

  4  If door edge opposite the hinges 

needs to move up, move plate 

toward outside of door. If door edge 

needs to move down, move plate 

toward inside of door. Repeat until 

top edge of door is parallel with 

top of cabinet and tighten screws 

securely.

  5  After adjustment is complete, remove 

the door closers from the bottom 

hinge, clean thoroughly and apply 

petroleum jelly to the mating surfaces 

of the closers (Figure 3). Be sure that 

bosses on closers align with holes in 

hinge and hinge plate. Mount door 

and install top hinge pivot pin.

Your door is aligned at the factory before 

shipment. Occasional re-adjustment may 

be necessary, especially if an overlay panel 

is installed. The following procedure will 

correct for up to 1/4” alignment.
The door should never be flush with the 

top of the cabinet. Even when level, the 

top edge of the door will be 1/8” below the 

top of the cabinet (Figure 1).

Figure 3

Door

Closer

Inserts

Boss

Figure 2

1/8" Allen

Wrench

Figure 1

1/8"

To adjust :
  1  Compare the top edge of the door 

(opposite the hinges) to the top edge 

of the cabinet and note the type of 

adjustment (up or down) needed.

  2  Remove the top hinge pivot pin with 

a 1/8" Allen wrench (Figure 2) and lift 

door off bottom hinge pin. Be careful 

not to lose door closers (Figure 3).

  3  With door upside-down, loosen but do 

not remove the two hinge plate screws.