Electrolux E36DF76PPS オーナーマニュアル

tions:

•   Allow the oven to cool before cleaning.

•   Wear rubber gloves when cleaning any exterior parts of the 

oven manually.

During the self-cleaning cycle, the outside of the range can 

become very hot to the touch. DO NOT leave a small children 

unattended near the range.

Before cleaning any part of the oven, be sure the oven is turned 

off. Wait until the oven is cool.

Do Hand Clean Door Area 

which out of the Door Gasket

Do Hand 

Clean 

Frame

Do NOT 

Hand 

Clean Door 

Gasket

cautioN

DO NOT use commercial oven cleaners or oven protective coatings in or around any part 

of the self-cleaning oven. 

DO NOT clean the oven door gasket. The gasket on the oven 

door is essential for a good seal. Care should be taken not to rub, damage or move the 

gasket. 

DO NOT use any cleaning materials on the gasket. Doing so could damage it. DO

NOT use aluminum foil to line the oven bottom. This may affect cooking or foil could melt 

and damage the oven surface.

A self-cleaning oven cleans itself with high temperatures (well above cooking tempera-

tures) which eliminate soil completely or reduce it to a fine powdered ash you can whisk 

away with damp cloth.

1.  

Remove any excess spillovers in the oven cavity before starting the self-cleaning 

cycle. To clean, use hot soapy water and a cloth. Large spillovers can cause smoke or 

a fire when subjected to high temperatures. 

DO NOT allow food spills with a high sugar 

or acid content (such as tomatoes, sauerkraut, fruit juices or pie filling) to remain on the 

surface as they may leave a dull spot even after cleaning.

2.  Clean any soil from the oven frame and the door liner (see illustration). These areas 

heat sufficiently during a self-clean to burn soil on. Clean with hot soapy water. 

3.  Remove all utensils and any foil. These items cannot withstand high cleaning tempera-

tures.

4.  Oven racks and oven rack supports must be removed. If they are not removed the self-

cleaning cycle cannot start and the “ Racks” Indicator Light will begin to flash indicating 

that you must remove the racks and rack gliders with the supports before starting the 

clean cycle. When the cycle has finished and the door can be opened, replace the oven 

the oven rack supports and oven racks.