Electrolux EI32AR80QS オーナーマニュアル

1.  Remove handle from carton and any other 

protective packaging. 

2.   Position refrigerator handle end caps over upper 

and lower pre-installed shoulder bolts (A) that 
are fastened into door, ensuring the holes for the 
set screws are facing towards the outside of door 
if a single unit installation or the freezer door (if 
installing the matching freezer) 

3.    While holding handle fi rmly against door, fasten 

upper and lower Allen set screws (B) with supplied 
Allen wrench. 

4.    Repeat steps 2 and 3 to install freezer handle 

(if installing the matching freezer).  Ensure the 
holes for the set screws are facing towards the 
refrigerator door.

To remove the toe grille, use a Phillips head 
screwdriver and remove the two screws holding the 
toe grille to the cabinet.  Then pull the toe grille away 
from the unit.

• 

The refrigerator must have all bottom corners 
resting fi rmly on a solid fl oor.

• The 

fl oor must be strong enough to support a fully 

loaded refrigerator.  

• It 

is 

VERY IMPORTANT for your refrigerator 

to be level in order to function properly.  If the 
refrigerator is not leveled during installation, 
the door may be misaligned and not close or 
seal properly, causing cooling, frost or moisture 
problems.

Leveling instructions continued on next page.

 

A

B

All set screws should be tightened and sub-fl ush 
(Allen set screw should be seated just below the 
surface of the end cap) of handle end cap.  The end 
caps should be drawn tight to refrigerator door with 
no gaps.