Electrolux EI30EW45JS インストール手順
5
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
(and Optional Electric or Gas Cooktop Combination)
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system (see figure 4):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system (see figure 4):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
connect appliance and power supply cable wires as
connect appliance and power supply cable wires as
shown in Figure 4.
Model and Serial Number Location
The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial
plate on your oven.
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial
plate on your oven.
Single Wall Oven
Serial Plate Location
Serial Plate Location
Double Wall Oven
Serial Plate Location
Serial Plate Location
Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instruction can result in injury
• Failure to follow this instruction can result in injury
or damage to the unit.
5. Cabinet Installation
IMPORTANT
Do not lift the oven by the door handle.
Handle
On Double Wall Oven: Pull the two handles out to
lift or carry the appliance. When you are done moving
the appliance, push back in the two handles.
the appliance, push back in the two handles.
1
Unpack the wall oven. Remove the bottom trim
taped on the oven side panel.
2
Find the 2 anti-tip mounting screws included in the
literature package.
3
Insert the oven into the cabinet opening. Slide oven
inward leaving 1½" (3.8 cm) clearance between the
oven and front of cabinet (see Figure 5).
oven and front of cabinet (see Figure 5).
4
Pull the armored cable through the hole for it in the
cabinet and toward the junction box while moving the
appliance inward.
appliance inward.
5
Push the oven in and against the cabinet.
Figure 4
4-WIRE GROUNDED JUNCTION BOX
Cable from Power Supply
White Wire
Junction Box
Cable from appliance
White Wire
Black
Wires
Red
Wires
Ground Wire
Ground Wire
(Bare or Green
Wire)
U.L.-Listed Conduit
Connector (or CSA
listed)