Electrolux EIMGD60JIW オーナーマニュアル

Before calling for service, review this list. It may save both time and expense. The list includes common 
occurrences that are not the result of defective workmanship or materials in this dryer.

OCCURRENCE

POSSIBLE CAUSE

SOLUTION

Dryer does not start.

Electrical power cord is not securely plugged 
in or plug may be loose.

Make sure the plug fi ts tightly in wall outlet.

House fuse blown or circuit breaker tripped.

Reset circuit breaker or replace fuse. 

Make sure electrical line is not overloaded and the 
dryer is on a separate circuit.

Thermal limiter tripped.

Call authorized service person for replacement.

LCD displays
DEMO MODE.

Dryer has been programmed to temporarily 
perform a repeating demo cycle.

To return to the factory default settings, press and hold 
the temperature and dryness buttons at the same ftime 
or 5 seconds.

Dryer runs but won’t 
heat.

There are 2 house fuses in the dryer circuit. If 1 
of the 2 fuses is blown, the drum may turn but 
the heater will not operate. (electric models)

Replace fuse.

Gas supply valve is not open (gas models).

Check to make sure supply valve is open. See INSTAL-
LATION INSTRUCTIONS for procedure.

Dryer does not have enough air supply to 
support the burner fl ame (gas models).

See INSTALLATION INSTRUCTIONS.

LP gas supply tank is empty or there has been 
a utility interruption of natural gas (gas models).

Refi ll or replace tank.
Dryer should heat when utility service is restored.

Drying cycle takes too 
long, outside of the 
dryer feels too hot or 
smells hot.

Lint fi lter is clogged with lint.

Make sure all lint has been removed from the dryer lint 
fi lter before starting each cycle.

Exhaust duct requirements have not been 
met.

Exhaust duct must be at least 4 inches in diameter and 
made of rigid or semi-rigid metal.

When in place, the duct must have no more than 
four 90° bends and must not exceed length listed in 
INSTALLATION INSTRUCTIONS.

Electric dryer is connected to a 208 volt 
circuit.

Drying time will be 20% longer than drying on a 240 
volt circuit.

Drying procedures have not been followed.

See “Operating Instructions.”

Outside exhaust hood or exhaust duct may 
be clogged or restricted.

Clean out any obstruction.

High humidity.

Use a dehumidifi er near the dryer.

Excessive wrinkling.

Dryer is overloaded.

Do not overload. See “Operating Instructions.”

Items left in dryer too long.

Remove items as soon as cycle ends.

Insuffi cient sorting of items.

See “Operating Instructions.”

Drying temperature too high.

Follow fabric care label instructions.

Scratching or chipping 
of the drum fi nish.

Foreign objects such as coins, pins, clips or 
buttons are inside the dryer.*

Always remove foreign objects from pockets before 
laundering. Remove objects from drum and restart dryer.

Permanently attached items such as belt 
buckles, zippers and fasteners may be hitting 
the inside of the drum.*

It may be necessary to sew a scrap of material 
securely around ornaments before drying to prevent 
scratching and damage to the dryer.

*Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.