Electrolux EIMGD60JIW インストール手順

ELECTRICAL SHOCK HAZARD

This appliance MUST be properly grounded. 

• 

Electrical shock can result if the dryer is not 
properly grounded. Follow the instructions in 
this manual for proper grounding.

Do not use an extension cord with this dryer. 

• 

Some extension cords are not designed to 
withstand the amounts of electrical current this 
dryer utilizes and can melt, creating electrical 
shock and/or fi re hazard. Locate the dryer 
within reach of the receptacle for the length 
power cord to be purchased, allowing some 
slack in the cord. Refer to the pre-installation 
requirements in this manual for the proper 
power cord to be purchased.

ELECTRICAL SHOCK HAZARD

Improper connection of the equipment grounding 
conductor can result in a risk of electrical shock. 
Check with a licensed electrician if you are in 
doubt as to whether the appliance is properly 
grounded.

The following are specifi c requirements for proper 
and safe electrical installation of your dryer. Failure 
to follow these instructions can create electrical 
shock and/or a fi re hazard.

Dryers operating on 208 volt power supply will 
have longer drying times than dryers operating 
on 240 volt power supply.

For a grounded, cord-connected dryer:

1.  The dryer MUST be grounded. In the event of 

a malfunction or breakdown, grounding will 
reduce the risk of electrical shock by a path of 
least resistance for electrical current.

2.  After you purchase and install a 3 wire or 4 

wire power supply cord having an equipment-
grounding conductor and a grounding plug 
that matches your wiring system, the plug 
MUST be plugged into an appropriate, copper 
wired receptacle that is properly installed and 
grounded in accordance with all local codes and 
ordinances. If in doubt, call a licensed electrician.

3.  DO NOT modify the plug you’ve installed on 

this appliance. If it will not fi t the outlet, have a 
proper outlet installed by a qualifi ed electrician. 

For a permanently connected dryer:

1.  The dryer MUST be connected to a grounded 

metal, permanent wiring system; or an 
equipment grounding conductor must be run 
with the circuit conductors and connected to 
the equipment-grounding terminal or lead on 
the appliance.

ELECTRICAL SHOCK HAZARD

A U.L.-approved strain relief must be installed 

• 

onto power cord. If the strain relief is not 
attached, the cord can be pulled out of the 
dryer and can be cut by any movement of the 
cord, resulting in electrical shock.

Do not use an aluminum wired receptacle with 

• 

a copper wired power cord and plug (or vice 
versa). A chemical reaction occurs between 
copper and aluminum and can cause electrical 
shorts. The proper wiring and receptacle is a 
copper wired power cord with a copper wired 
receptacle.