Philips BDL4620QL/00 ユーザーズマニュアル

BDL4620QL

v

The equipment should draw power from a socket with an attached 

protection circuit (a three-prong socket). All equipment that works 

together (computer, display, printer, and so on) should have the same 

power supply source.
The phasing conductor of the room’s electrical installation should have 

a reserve short-circuit protection device in the form of a fuse with a 

nominal value no larger than 16 amperes (A).
To completely switch off the equipment, the power supply cable must 

be removed from the power supply socket, which should be located 

near the equipment and easily accessible.
A protection mark “B” confirms that the equipment is in compliance 

with the protection usage requirements of standards PN-93/T-42107 

and PN-89/E-06251.

1.  We manufacture and sell many products targeted at consumers, 

which, like any electronic apparatus, in general have the ability to 

emit and receive electromagnetic signals.

2.  One of our leading Business Principles is to take all necessary health 

and safety measures for our products, to comply with all applicable 

legal requirements and to stay well within the EMF standards 

applicable at the time of producing the products.

3.  We are committed to develop, produce and market products that 

cause no adverse health effects.

4.  We confirm that if its products are handled properly for their 

intended use, they are safe to use according to scientific evidence 

available today.

5.  We play an active role in the development of international EMF and 

safety standards, enabling us to anticipate further developments in 

standardization for early integration in its products.

(A)

(B)

This apparatus is supplied with an approved moulded 13A plug. To 

change a fuse in this type of plug proceed as follows:
1.  Remove fuse cover and fuse.
2.  Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI approved 

type.

3.  Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut 

off and an appropriate 3-pin plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A. If a plug 

without a fuse is used, the fuse at the distribution board should not be 

greater than 5A.
NOTE:   The severed plug must be destroyed to avoid a possible shock 

hazard should it be inserted into a 13A socket elsewhere.

The wires in the mains lead are coloured in accordance with the 

following code:

BLUE – “NEUTRAL” (“N”)
BROWN – “LIVE” (“L”)
GREEN & YELLOW – “EARTH” (“E”)

1.  The GREEN & YELLOW wire must be connected to the terminal in 

the plug which is marked with the letter “E” or by the Earth symbol 

or coloured GREEN or GREEN & YELLOW.

2.  The BLUE wire must be connected to the terminal which is marked 

with the letter “N” or coloured BLACK.

3.  The BROWN wire must be connected to the terminal which 

marked with the letter “L” or coloured RED.

Before replacing the plug cover, make certain that the cord grip is 

clamped over the sheath of the lead – not simply over the three wires.