Epson SP4900DES ユーザーズマニュアル
H
Press the d/u buttons to select Roll Paper
Length
Length
, and then press the r button.
I
Press the d/u buttons to set the length of the roll
paper, and then press the Z button.
paper, and then press the Z button.
J
Press the l button to return to the previous
screen.
screen.
K
Press the d/u buttons to select Roll Length
Alert
Alert
, and then press the r button.
L
Press the d/u buttons to set when to display the
running low warning (amount of remaining roll
paper), and then press the Z button.
running low warning (amount of remaining roll
paper), and then press the Z button.
M
Press the W button to close the Menu.
Setting Auto Roll Paper Feeding
The factory setting for Auto Roll Feeding is On.
When using the Epson special media UltraSmooth Fine
Art Paper, set Auto Roll Feeding to Off from the Menu
before loading it in the printer. If UltraSmooth Fine Art
Paper is loaded while Auto Roll Feeding is set to On, the
roller of the paper presser may leave a mark on the
surface of the paper.
Art Paper, set Auto Roll Feeding to Off from the Menu
before loading it in the printer. If UltraSmooth Fine Art
Paper is loaded while Auto Roll Feeding is set to On, the
roller of the paper presser may leave a mark on the
surface of the paper.
When using paper other than UltraSmooth Fine Art
Paper, set it to On.
Paper, set it to On.
Tip:
The following differences in operation occur when
turning this setting from On to Off.
The following differences in operation occur when
turning this setting from On to Off.
❏ An error occurs if you try to switch to Cut Sheet in
the Paper Type menu while roll paper is loaded.
Remove the roll paper and then change to Cut
Sheet
Remove the roll paper and then change to Cut
Sheet
.
❏ An error occurs if you try to print by specifying the
paper cassette from the printer driver while roll
paper is loaded. Remove the roll paper, change to
Cut Sheet
paper is loaded. Remove the roll paper, change to
Cut Sheet
in the Paper Type menu, and then try
again.
When using UltraSmooth Fine Art Paper, change the
setting using the following procedure.
setting using the following procedure.
A
Make sure the printer is on.
B
Check that paper is not loaded in the printer, and
then press the r button to display the Menu.
then press the r button to display the Menu.
C
Press the d/u buttons to select Printer Setup,
and then press the r button.
and then press the r button.
D
Select Auto Roll Feeding, and then press the r
button.
button.
E
Press the d/u buttons to select Off, and then
press the Z button.
press the Z button.
F
Press the W button to close the Menu.
Loading Roll Paper
Removing and installing the
attachment
attachment
Load the roll paper into the printer after placing it on the
spindle supplied with this printer.
spindle supplied with this printer.
Depending on the size of the paper core, follow the steps
below to install or remove the attachment from the
spindle.
below to install or remove the attachment from the
spindle.
❏ For two inch paper cores
The attachment is not necessary.
Because the attachment is installed on the spindle at
the time of purchase, you need to remove it before
use.
the time of purchase, you need to remove it before
use.
You may need the attachment for roll paper with a
three inch paper core, make sure you keep it in a safe
place after removing it.
three inch paper core, make sure you keep it in a safe
place after removing it.
❏ For three inch paper cores
The attachment is necessary.
Epson Stylus Pro 4900/4910 User's Guide
Basic Operations
27