Desa CGESBL ユーザーズマニュアル

ページ / 12
www.desatech.com
117190-01A
6
CLEANING AND 
MAINTENANCE
  WARNING: Always  discon-
nect power and allow the heater 
to  cool  before  performing  any 
cleaning, maintenance or reloca-
tion of this heater. Turn controls 
to  OFF  and  remove  plug  from 
outlet or turn off circuit breaker 
to heater.
Turn off heater and circuit breaker to heater before 
performing any cleaning and/or maintenance. Al-
low heater to cool completely.
BULB REPLACEMENT
 WARNING: The halogen light 
bulbs  in  your  unit  can  become 
extremely hot. Allow at least 10 
minutes between turning off the 
heater  and  removing  the  light 
bulbs to avoid accidental burns.
There are a total of 7 ( halogen light bulbs (type 
GX6.35 rated 120 volts, 35 watts) in your unit.
•  2 bulbs provide illumination for the ember bed 
beneath the log set 
•  2  bulbs  provide  illumination  for  the  flame 
generation assembly
•  1 bulb provides illumination for the top con-
trasting light
•  2 bulbs for replacement
Most halogen light bulbs are rated to last approxi-
mately 1800 hours. Like all light bulbs, halogen 
bulbs  require  periodic  replacement. When  the 
bulbs in your unit have burned out you will notice 
or more of the following:
•  Contrasting light is dark
•  Flame is dim or dark in certain areas
•  Log  set  ember  bed  appears  dim  or  dark  in 
certain areas
  WARNING:  Do  not  install 
replacement bulbs that exceed 
specified maximum watts.
Your unit must be opened in order to replace the 
light bulbs. To reduce the number of times you 
need  to  open  the  unit,  replace  all  bulbs  at  the 
same time. 
Removing Top of Unit
1.  Unplug unit from the power supply.
2.  Remove the two screws at the rear of the unit 
which secure the top to the back frame. 
3.  Two clips hold the top to the sides. Push the 
top of the unit toward the back until the clips 
disconnect. Remove top of the unit and place 
face up on the floor.
4.  Unscrew the 4 screws from the metal plate 
and set plate aside.
Figure 5 - Stove Top Removal
Replacing Top Contrasting Bulb
1.  The housing for the top contrasting light is 
connected to the top of the mirror. Remove 
housing from mirror by gently lifting up.
 CAUTION: Do not force the 
light housing off the mirror. This 
may  damage  the  mirror  (e.g. 
chipping, cracking, etc.)
2.  Remove screws from each side of housing.
3.  Carefully reach into the housing and remove 
spring clip. Hold socket and pull out the old 
bulb.
3.  Hold socket and push in new bulb (DO NOT 
exceed wattage). Replace spring clip.
4.   Set aside until all bulbs have been changed.
Figure 6 - Removing Housing and Top 
Contrasting Bulb
Screw
Housing
Mirror
Front of Stove