Sharp AR-C260 ユーザーズマニュアル

When a misfeed has occurred during printing, the message "MISFEED HAS OCCURRED." will appear in the touch
panel display of the operation panel and printing output will stop.The approximate locations of possible misfeeds are
indicated by "

" in the illustration below. The page numbers for detailed information for misfeed removal for each

are also shown.

Misfeed removal guidance can be displayed by touching the [INFORMATION] key on the touch panel after a misfeed
has occurred.

NOTE
If the machine is performing a scanning operation, vibrations resulting from hard operation of machine covers or
trays during misfeed removal will cause uneven scanning. Also if a hard disk drive unit is installed, it may
malfunction due to excessive vibration.

NOTES
● Be careful not to tear

the misfed paper
during removal.

● If paper is accidentally

torn during removal,
be sure to remove all
pieces.

● Take care not to

damage or leave
fingerprints on the
transfer belt when
removing the misfed
paper.

Misfeed in the fusing area,

and exit area (page 2-20)

Misfeed in the duplex 
bypass/inverter unit
(page 2-22)

Misfeed in the saddle 
stitch finisher (page 3-10)

Misfeed in the reversing
automatic document feeder
(see page 7-2 in the "Copy 
Functions" section)

Misfeed in the transport 
area (page 2-20)

Misfeed in the 500 sheet 
paper drawer
(page 2-19)

Misfeed in the duplex 
module/2 x 500 sheet 
paper drawer (page 2-22)

Misfeed in the stand/1 x 500 
sheet paper drawer or the 
stand/3 x 500 sheet paper 
drawer
 (page 2-21)

For misfeeds in an optional 
large capacity tray 
(page 3-17)

The fusing unit is hot. Take care in removing paper.

Upper fusing unit

Fusing unit paper guide

Transfer belt

INFORMATION

sec_whale_02-2.fm  18 ページ  ２００２年１１月１３日　水曜日　午後１０時２分