JVC CA-VSDT2000 ユーザーズマニュアル
15
Using the Powered Subwoofer
INPUT Terminals
The Subwoofer has the following INPUT terminals.
INPUT(LOW-LEVEL):
Usually, the LEFT/MONO terminal is connected to the SUBWOOFER terminal of the Center Unit with the supplied signal
cord. (see page 7.)
cord. (see page 7.)
When the Center Unit CA-VSDT2000 is not used (Using other equipment)
If an amplifier etc. to be connected does not have the SUB WOOFER OUT terminals, the RIGHT and LEFT/MONO ter-
minals will be connected to the LINE OUT-RIGHT and LEFT terminals of that unit.
minals will be connected to the LINE OUT-RIGHT and LEFT terminals of that unit.
INPUT (HIGH-LEVEL):
You can connect the speaker output terminals of other amplifier etc. to these terminals.
Connect the speaker cords in parallel to the speaker terminals on the amplifier etc.
Connect the speaker cords in parallel to the speaker terminals on the amplifier etc.
• Do not use the INPUT (LOW-LEVEL) terminals and the INPUT (HIGH-LEVEL) terminals at the same time.
LINE OUT
LEFT
RIGHT
Connecting cord
(not supplied)
(not supplied)
Amplifier etc.
SPEAKER
LEFT
RIGHT
Amplifier
etc.
etc.
Speaker cords
(not supplied)
(not supplied)
VS-DT2000(J)_EN.book Page 15 Wednesday, February 6, 2002 4:37 PM