JVC CA-VSDT2000 ユーザーズマニュアル

ページ / 32
25
Care And Maintenance
Handle your CDs carefully, and they will last a long time.
Compact Discs
CAUTION:
• Do not use any solvent (for example, con-
ventional record cleaner, spray thinner,
benzine, etc.) to clean a CD.
General Notes
In general, you will have the best performance by keeping
your CDs and the mechanism clean.
• Store CDs in their cases, and keep them in cabinets or on 
shelves.
• Keep the System’s Panel closed when not in use.
Cleaning the unit
• Stains on the unit
Should be wiped off with a soft cloth. If the unit is heavily
stained, wipe it with a cloth soaked in water-diluted neutral
detergent and wrung well, then wipe clean with a dry cloth.
• Since the unit may deteriorate in quality, become damaged 
or get its paint peeled off, be careful about the followings.
- DO NOT wipe it with a hard cloth.
- DO NOT wipe it strong.
- DO NOT wipe it with thinner or benzine.
- DO NOT apply any volatile substance such as insecti-
cides to it.
- DO NOT allow any rubber or plastic to remain in con-
tact with it for a long time.
Moisture Condensation
• Only CDs bearing this mark can 
be used with this System. How-
ever, continued use of irregular 
shape CDs (heart-shape, octago-
nal, etc.) can damage the System.
• Remove the CD from its case by 
holding it at the edges while press-
ing the case’s center hole lightly.
• Do not touch the shiny surface of 
the CD, or bend the CD.
• Put the CD back in its case after 
use to prevent warping.
• Be careful not to scratch the sur-
face of the CD when placing it 
back in the case.
• Avoid exposure to direct sunlight, 
temperature extremes, and moisture. 
• A dirty CD may not play cor-
rectly. If a CD does become dirty, 
wipe it with a soft cloth in a 
straight line from center to edge. 
Moisture may condense on the lens
inside the System in the following
cases:
• After turning on heating in the 
room.
• In a damp room.
• If the System is brought directly 
from a cold to a warm place.
Should this occur, the System may
malfunction. In this case, leave the
System turned on for a few hours un-
til the moisture evaporates, unplug
the AC power cord, and then plug it
in again.
VS-DT2000(J)_EN.book  Page 25  Wednesday, February 6, 2002  4:37 PM