Marantz SR8400 ユーザーズマニュアル

SOURCE ON/OFF Turns the SR8400 on and off

POWER ON

Turns the SR8400 on

POWER OFF

Turns the SR8400 off

D1 - D5 / >(Page) (Refer to page vi)

VOL +/-

Adjust the over all sound level

MUTE

Decreases the sound temporarily

Cursor

Move the cursor for setting in"On screen display" mode

OK

Enter the  "On screen display"

Confirms the setting in "On screen display" mode

MENU

Displays the current setting on the monitor

EXIT

Exits from SETUP MENU

TEST (1)

Enter the test tone menu

CH.SEL (2)

Call up SETUP MENU and adjusts speaker levels or 7.1ch input

level

SURR (3)

Selects the surround mode

7.1CH  (4)

Selects the 7.1CH IN

ATT (5)

Reduces the input level

SPK-AB (6)

Selects the speaker system

DISP (7)

Changes the front display mode

OSD (8)

Selects the "On screen display" on and off

SLEEP (9)

Sets the sleep timer function

Function selector Selects a particular source component

D1 - D5 / >(Page) (Refer to page vi)

CH +/-

Selects a preset station up and down

GUIDE

Selects the "Frequency direct input"

0-9

Input the numeric

MEMO

Enter the tuner preset memory numbers

CLEAR

Clears the inputting

TUNER

Selects a frequency band

5

6

3

4

1

2

Example: Setting to 6:20PM (18:20)

When you bought this remote control and insert
the batteries to the remote control at first, the steps
1 to 3 are skipped.
Starts from step 4 to set the time.

Hold down the 

button for three seconds or

more.

The menu is displayed.

Press the 

 button once.

This displays second page (SETUP).

Press the 

 (CLOCK) direct button.

The  “ ” indicator blinks and the clock indicator

displays “0:00”.

Press the 

 and 

 numeric button to set the

hour indicator.

The hour indicator displays “18”.

The minute indicator blinks “_”.

Press the 

 and 

 numeric button to set the

minute indicator.

The minute indicator displays “20”.

The hour indicator blinks.

Press the 

cursor button to start the clock.

The clock starts from 0 second at the time that was

set and return to normal (USE) mode.

Whenever the batteries are replaced, the clock
shows 00:00. Please reset the clock. (The time
setting is not backed up.)

To check the time, hold down the 

 button for three

seconds or more. The current time is displayed for
five seconds.

Although the remote control uses a quartz clock,
the time may become out of sync over the course
of operation. Be sure to correct the clock from time
to time.

To control the SR8400 by your RC1400, you have
to select the device AMP or TUNER by pressing
the function selector button.  Please refer  below
for the details in AMP and TUNER mode.

SR8400U DFU_01_ENG 1_2

04.1.7, 11:36 AM

Page 10

Adobe PageMaker 6.5J/PPC