Panasonic AJ-SPC700 P ユーザーズマニュアル
67
5
Chapter 5 Preparation
(continued)
5-1-2 Using an AC Power Supply
When using the Panasonic AJ-B75 AC adapter
1
Plug the AJ-B75 DC OUT connector into the camera-
recorder’s external DC input socket.
recorder’s external DC input socket.
2
Turn the AC adapter power ON.
3
Turn the camera-recorder power switch ON.
<Notes>
z When both the battery pack and AC adapter are
connected, power is supplied from the AC adapter.
The battery can be removed or mounted while using
the AC adapter.
The battery can be removed or mounted while using
the AC adapter.
z When using the AC adapter, make sure you turn ON
the AC adapter power before turning ON the camera-
recorder’s power switch. If this sequence is reversed,
the camera-recorder may malfunction due to slow
rising of the AC adapter output voltage.
recorder’s power switch. If this sequence is reversed,
the camera-recorder may malfunction due to slow
rising of the AC adapter output voltage.
z When connecting a battery to the DC IN socket,
select the battery type listed under EXT DC IN
SELECT. Select EXT DC IN SELECT from the
<BATTERY/P2CARD> screen on the MAIN
OPERATION page. In this case, however, the %
display is disabled, even when using a digital battery.
SELECT. Select EXT DC IN SELECT from the
<BATTERY/P2CARD> screen on the MAIN
OPERATION page. In this case, however, the %
display is disabled, even when using a digital battery.
5-2 Mounting the Viewfinder and
Adjusting its Position
Please refer to the viewfinder instruction manual.
Note: A slide rail is required to mount any viewfinder other
than models AJ-VF15B or AJ-VF20WB.
Note: A slide rail is required to mount any viewfinder other
than models AJ-VF15B or AJ-VF20WB.
z If you need to buy a slide rail, please contact the store
where you purchased the camera-recorder and tell them
that the slide rail is a “repair part”.
that the slide rail is a “repair part”.
Slide rail (VFC3995)
Screws (XBS3+8VZ)
Screws (XBS3+8VZ)
Mounting the Slide Rail
1
Undo the upper two screws for AJ-VF15 or AJ-VF20W,
and remove the mounting unit.
Leave the screws attached to the mounting unit.
and remove the mounting unit.
Leave the screws attached to the mounting unit.
2
Mount the slide rail, then tighten the two screws.
DC IN Socket
AC Adapter
z AJ-B75 (Optional)
z AJ-B75 (Optional)
When using an external power supply other than the AC
adapter AJ-B75, check the DC IN socket pin information to
ensure correct polarity. If a +12V power supply is
accidentally connected to the GND terminal, this could
cause a fire or personal injury.
adapter AJ-B75, check the DC IN socket pin information to
ensure correct polarity. If a +12V power supply is
accidentally connected to the GND terminal, this could
cause a fire or personal injury.
1
2
3
4
Pin No.
Signal
1
GND
2, 3
—
4
+12V
DC IN Socket
Mounting unit
Screws
Slide rail
#,52%2
'PINKUJDQQMࡍࠫ㧞㧜㧜㧡ᐕ㧝㧞㧤ᣣޓᧁᦐᣣޓඦᓟ㧝㧞ᤨ㧠㧥ಽ