JVC GY-HMQ10E ユーザーズマニュアル

Applicable to: Camera mode
There are two ways to input audio sound.

A 

Built-in microphone

B 

[INPUT1] terminal / [INPUT2] terminal

0

The priority order of the input is in the sequence of B>A.

0

When you want to use the built-in microphone, remove the audio

unit cable from the [AUDIO IN] terminal.

0

To use the [INPUT1/INPUT2] terminal, an optional microphone

is needed.

.

[INPUT1/INPUT2] terminal

Audio Unit Cable

Built-in microphone

Applicable to: Full Auto shooting mode A, Manual shooting mode
M

o

Set “AUDIO REF. LEVEL” in the recording menu.

Applicable to: Full Auto shooting mode A, Manual shooting mode
M

o

Set “INTERNAL MIC LEVEL” in the recording menu (“-2” to “+2”).

* Microphone is optional.
Applicable to: Full Auto shooting mode A, Manual shooting mode
M
Preparation: Connect a microphone to the [INPUT1/INPUT2]

terminal.

INPUT1

Input to [CH1(L)] at all times. Input to [CH2(R)] can

be enabled using the [CH-2 INPUT] switch.

INPUT2

Input to [CH2(R)] can be enabled using the [CH-2

INPUT] switch.

o

Configure the [CH-2 INPUT] switch.

0

INPUT1: Inputs audio from the [INPUT1] connector to [CH-2].

0

INPUT2: Inputs audio from the [INPUT2] connector to [CH-2].

0

Audio from the [INPUT1] connector is also input to [CH-1]

regardless of the setting.

o

Configure the [AUDIO INPUT 1/2] switch.

LINE

Use this setting when connecting to an audio device

or other equipment.

MIC

Use this setting when connecting to a dynamic

microphone.

MIC+48V

Use this setting when connecting to a microphone

that requires a +48V power supply (phantom

microphone).

0

When connecting a device that does not require a +48 V power

supply, make sure that it is not set to the [MIC+48V] position.