JVC GY-HMQ10E ユーザーズマニュアル

RECOVERY OF FILE

FAILED UNABLE TO

RECORD FURTHER

WITH THIS

COMBINATION OF

CARDS

0

Adjust the number of files on the four cards to a consistent number by using a computer to delete the

maximum file number in the folder with the maximum number.

Alternatively, copy all the files to a computer, and format the SD cards.

0

This unit is a microcomputer-controlled device. Electrostatic discharge, external noise and interference (from a TV, a radio, etc.) might

prevent it from functioning properly.

In such a case, turn off the power, then remove the AC adapter and battery pack. This unit will be reset.

Before sending for repair, check the camera recorder’s problem according to the table below.
If the problem persists, consult your nearest JVC dealer or JVC service center.

SDHC/SDXC card

cannot be inserted.

0

Check that the SDHC/SDXC card is facing the right direction.

Power does not turn

on.

0

Is the AC adapter properly connected?

0

Is the battery charged?

0

Is the power turned on immediately after it is turned off? Make sure to wait for an interval of at least 5 seconds

before turning on the power again.

Unable to start

recording.

0

Is the SDHC/SDXC card properly set?

4K2K recording (4K2K mode):

Are the combination and sequence of the four SDHC/SDXC cards correct?

Insert the cards into the slots according to the combination and sequence during formatting.
HD recording (1920 mode):

Is an SDHC/SDXC card inserted into slot A?

0

Is the write protection switch of the SDHC/SDXC card turned on?

Turn off write protection if it is on.

0

Is the unit in the Camera mode?

If the [CAM] indicating lamp does not light up in red, camera images are not output.

Set the [CAM/MEDIA] switch to the [CAM] side to set to the Camera mode.

Camera image is not

output on the LCD

monitor or

viewfinder screen.

0

Is the camera recorder set to the Camera mode?

If the [CAM] indicating lamp does not light up in red, camera images are not output.

Set the [CAM/MEDIA] switch to the [CAM] side to switch to the Camera mode.

0

Is the viewfinder used with “PRIORITY SETTING” in the common menu set to “VIEWFINDER” and without pulling

out the viewfinder?

Pull out the viewfinder if this setting is used.