JVC DPT 115 ユーザーズマニュアル

It will be necessary to disassemble pan and tilt mechanism from base of  DPT unit to gain access 
to the configuration jumpers on the MPU PWA. The MPU PWA is the top board and will be 
accessible as soon as the pan and tilt mechanism is removed. The following steps describe 
reconfiguring the jumpers. The equipment necessary for this procedure are a No. 2 Phillips screw 
driver a small pair of needle nose pliers and a 2” x 8” x 8” block of some type. Verify the DC 
jack providing power to the unit has been removed prior to proceeding. 

5.  Position the pan and tilt at the parked or normal position. This position is defined as the 

camera mounting plate being horizontal to the work surface and the two video BNC 
connectors on the pan and tilt being on the same side facing the individual working on 
the unit. 

6.  Remove the four Phillips head screws fastening the pan and tilt mechanism to the base. 

7.  Position the block directly behind the pan and tilt unit. 

8.  Remove pan and tilt mechanism by lifting slightly and rotating away from you, this step 

will leave the pan and tilt mechanism laying on the side away from the BNC connector 
behind the base. 

9.  The three position jumper posts will now be accessible at the far left corner of the PWA. 

10. Place the pan and tilt mechanism back on the base. 

11. Replace the four Phillips head screws fastening the pan and tilt mechanism to the base. 

 

 

 

 

 

 

 

 

 
 

 

 

 

 

 

2/12/05  

Document D0153

 

18