Mitsubishi Electronics DX-TL16U ユーザーズマニュアル
User’s Manual
24
Motion Settings (EVENT
Motion Tab)
Figure 15
─ Motion setup screen.
Your DVR has built-in video motion detection. Video motion detection can be turned On or Off for each
camera.
camera.
Highlighting the box under the Sensitivity heading and pressing the
button
allows you to adjust the DVR’s sensitivity to motion for Daytime and
Nighttime independently. There are five settings with 1 being the least
sensitive and 5 being the most sensitive.
Nighttime independently. There are five settings with 1 being the least
sensitive and 5 being the most sensitive.
You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box
under the Zone heading, and press the
under the Zone heading, and press the
button. The Motion Detection Zone screen displays.
Press the
button to display the menu screen. The menu on the setup screen has the following functions:
You can adjust the minimum number of detection blocks that must be
activated to trigger a motion alarm. Highlighting the box under the Min.
Blocks heading and pressing the
activated to trigger a motion alarm. Highlighting the box under the Min.
Blocks heading and pressing the
button allow you to adjust the minimum
number of detection blocks for Daytime and Nighttime independently.
Smaller numbers provide greater sensitivity because fewer detection blocks
must be activated.
Smaller numbers provide greater sensitivity because fewer detection blocks
must be activated.
The Motion Detection Zone screen is laid over the video for the
selected camera. You can set up motion detection zones by selecting
or clearing blocks.
selected camera. You can set up motion detection zones by selecting
or clearing blocks.
NOTE: You can set up motion zones one block at a time in groups
of 8 individual block groups. A block group is positioned within
the image area using the Up and Down arrow buttons, and
individual blocks within the block groups are selected or cleared
using the camera buttons.
of 8 individual block groups. A block group is positioned within
the image area using the Up and Down arrow buttons, and
individual blocks within the block groups are selected or cleared
using the camera buttons.
Select ─ Activates highlighted blocks to detect motion.
Clear
Clear
─ Deactivates highlighted blocks so that they will not detect motion.
Reverse ─ Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All ─ Activates all blocks to detect motion.
Clear All ─ Deactivates all blocks so that they will not detect motion.
Reverse All ─ Activates inactive blocks and deactivates active blocks.
Zone View ─ Displays any detected motion within the zone in red.
OK ─ Accepts changes and closes Zone setup.
Cancel ─ Exits Zone setup without saving changes.
Select All ─ Activates all blocks to detect motion.
Clear All ─ Deactivates all blocks so that they will not detect motion.
Reverse All ─ Activates inactive blocks and deactivates active blocks.
Zone View ─ Displays any detected motion within the zone in red.
OK ─ Accepts changes and closes Zone setup.
Cancel ─ Exits Zone setup without saving changes.