Mitsubishi Electronics XD8600 ユーザーズマニュアル

EN-49

11. Press the ENTER button.

12. Select an item you want to set by pressing the  or 



 button.

•  Adjust the black level in areas other than the

overlapped areas. 

•  When you set INTERLOCKED to ON, you can

adjust RED, GREEN, and BLUE simultaneously. 
When you set it to OFF, you can adjust RED, 
GREEN, and BLUE separately. 

13. Select a setting value by pressing the  or  button. 
Repeat steps 12 to 13, if necessary. 
14. Press the MENU button once. 
15. Select BRIGHT UNIFORMITY CORRECTION   by 

pressing the  or  button. 
•  When EDGE BLENDING is ON, the brightness of

the projected images is made even.

16. Press the ENTER button.

•  The BRIGHT UNIFORMITY CORRECTION

dialog box and the correction position marker 
are displayed. 

POSITION : 

SELECT : ENTER

Correction position marker

BRIGHT UNIFORMITY CORRECTION dialog box

•  Every time you press the ENTER button, the 

BRIGHT UNIFORMITY CORRECTION dialog box 
shows POSITION and LEVEL alternately. 

POSITION : 

SELECT : ENTER

 

Press the , , , or  
button to move the correction 
position marker.

 

LEVEL : 

100

SELECT : ENTER

Press the , or  button to 
adjust the correction amount. 

17. Cancel the BRIGHT UNIFORMITY CORRECTION 

dialog box. 

  Press any button other than the , , , or , 

and ENTER buttons to clear the dialog box.

  Or, the dialog box disappears in 10 seconds after 

the last use.

18. Press the MENU button. 

You can configure a multi-screen display using 
multiple projectors. 
You can make the joints of the images displayed on 
the projectors unnoticeable and adjust the differences 
in the brightness and the color tint of them. 
Important:

•  Depending on the installation condition, the projected

image may fluctuate due to the effect of the exhausted 

wind. In such a case, open up the space between 

the projectors so that the image doesn’t fluctuate 
(approximately 70 cm or more).

You can make the joints of the images projected on 
the projectors unnoticeable using the menu settings. 
(See page 31 for menu setting.) 
1.  Display the MULTI-SCREEN menu. 
2.  Select EDGE BLENDING by pressing the  or  button. 

3.  Select ON by pressing the  or  button. 
4.  Select SETTING by pressing the  or  button. 

5.  Select EDGE ADJUST   by pressing the  or  

button. 

6.  Press the ENTER button.

7.  Select an item you want to set by pressing the  or 



 button.

  Select the joint you want to adjust from UP, LOW, 

LEFT, and RIGHT.
BLENDING

  When you select ON, the joint selected by EDGE 

SELECT becomes unnoticeable. 
START POSITION

  Set the position to start the edge adjustment.
  When UP or LOW is selected:  

0 to 192

  When LEFT or RIGHT is selected:  0 to 256

  Set the width of the overlap of the joint selected by 

EDGE SELECT. 

  When UP or LOW is selected:  

4 to 368

  When LEFT or RIGHT is selected:  4 to 496

•  The setting range of START POSITION and

WIDTH vary depending on their setting values.

  When you select ON, a marker for easily locating 

the overlap of the joint is displayed.

8.  Select a setting value by pressing the  or  button. 
Repeat steps 7 to 8, if necessary. 
9.  Press the MENU button once. 
10. Select BLACK LEVEL   by pressing the  or  

button.