KitchenAid Gas Range Architect Series II ユーザーズマニュアル

24

Removing and replacing the Warming

Drawer

 Electrical shock hazard can occur

and result in serious injury or death. Disconnect

appliance from electric power before cleaning

and servicing the warming drawer.
To remove the warming drawer:

1. Turn power OFF to the appliance before removing the

warming drawer.

2. Open the warming drawer completely.
3. On left warming drawer rail, locate black release lever

and press up with finger while pulling out slightly on the

oven drawer handle. On right warming drawer rail,

locate black release lever and press down with finger

while pulling out slightly on the warming drawer handle

(See Fig. 1).

4. The warming drawer should now be released from the

rails. Remove warmer oven drawer (using level &

square motion) completely out and away from the

appliance.

To replace the warming drawer:

1. Pull the bearing glides to the front of the outer

compartment glide channels until they snap into place

(See Fig. 3).

2. Carefully line up both sides of the warming drawer

glide rails to the outer compartment glide channels

located inside the empty warming drawer compartment

(See Fig. 2).

3. While holding the warming drawer level and square

using the warming drawer handle, push (do not force)

the warming drawer all the way into the outer

compartment glide channels all the way into the range.

Open the warming drawer again to verify the glides

have seated.

4. If you do not hear the levers “click” or the bearing

glides do not feel seated remove the warming drawer

and repeat steps 1 through 3 again.  This will minimize

possible damage to the bearing glides.

Left-hand rail and release

Right-hand rail and release

Warmer
drawer
handle

Left-hand channel

Right-hand channel

Fig. 1

Fig. 2

Fig. 3

Warming Drawer (some models)