KitchenAid KGRS208X ユーザーズマニュアル

Oven control beeps and displays F

code error.

Oven control has detected a fault or error condition. Press OFF keypad to

clear the error code. Try Bake or Broil function. If the F code error repeats,

remove power from appliance, wait 5 minutes and then repower appliance

and set clock with the correct time of day. Try Bake or Broil function again. If

the fault recurs, press OFF to clear and see Assistance or Service section

of manual for assistance contact information.

Before You Call Solutions to common problems

Cannot move appliance easily.

Appliance must be accessible for

service.

Cabinets not square or are built in too tightly. Contact builder or installer to

make appliance accessible.

Carpet interferes with appliance. Provide sufficient space so appliance can

be lifted over carpet.

Gas line is hard-plumbed. Have a flexible CSA International approved

metal appliance connector installed.

Appliance is not level.

Be sure floor is level, strong & stable enough to adequately support range.
If floor is sagging or sloping, contact a carpenter to correct the situation.
Poor installation. Place oven rack in center of oven. Place a level on the

oven rack. Adjust leveling legs at base of appliance until the rack is level.

Kitchen cabinet alignment may make range appear not level. Be sure

cabinets are square & have sufficient room for appliance clearance.

Before you call for service, review the following list. It may save you time & expense. Possible solutions to these

problems are provided with the problem listed:

Entire appliance does not operate.

Make sure power cord is plugged properly into outlet.
Electrical power outage. Check house lights to be sure. Call your local

electric company for service outage information.

Service wiring is not complete. See Assistance or Service section of

manual for assistance contact information.

Problem

Solution

Poor baking results.

Many factors affect baking results. Make sure the proper oven rack position

is used. Center food in the oven and space pans to allow air to circulate.

Allow the oven to preheat to the set temperature before placing food in the

oven. Try adjusting the recipe's recommended temperature or baking time. If

you feel the oven is too hot or cool, see Adjusting oven temperature in

Setting Oven Controls section.

Oven portion of appliance does not

operate.

Be sure regulator gas valve is turned to ON. See installation instructions.
The time of day is not set. The time of day must first be set in order to

operate the oven. See Setting clock in Setting Oven Controls section.

Be sure the oven controls are set properly for the desired function. See

Setting Oven Controls section and review instructions for the desired

cooking function in this manual or see Entire appliance does not operate

in this checklist.