Hoshizaki 73180 ユーザーズマニュアル

57

12) Open the water supply line shut-off valve.
13) Plug the unit back in. Move the power switch to the "ON" position and allow the 

icemaker to run. Check for leaks.

14) After 30 minutes, move the power switch to the "OFF" position. Unplug the unit.
15) Pour warm water into the storage bin to melt all of the ice, then clean the storage bin 

liner, door liner, and door gasket with a neutral cleaner. Rinse thoroughly after cleaning.

16) Plug the unit back in. Move the power switch to the "ON" position to start the automatic 

icemaking process.

In some conditions, slime may build up inside the storage bin drain and prevent water 
from draining properly. To prevent this buildup, perform the following procedure once 
every 3 months or as often as necessary for conditions. 

If the storage bin drain becomes clogged, water could build up in the bin and 
overflow, leading to costly water damage.

1) Move the power switch to the "OFF" position. 

WARNING! To reduce the risk of 

2) Remove all ice from the storage bin.
3) Mix a batch of sanitizing solution by diluting 1.25 fl. oz. (37 ml or 2.5 tbs) of a 

5.25% sodium hypochlorite solution (chlorine bleach) with 2.5 gal. (9.5 l) of warm water. 
Using a chlorine test strip or other method, confirm that you have a concentration of 
about 200 ppm. 

4) Slowly pour the sanitizing solution into the storage bin.
5) After all of the solution has drained, clean the storage bin liner with a neutral cleaner. 

Rinse thoroughly with clean water.

6) Move the power switch to the "ON" position to start the automatic icemaking process.