ONKYO PR-SC5507 ユーザーズマニュアル

42

With 

u (Remote Interactive), you can use the follow-

ing special functions:

■ Auto Power On/Standby

When you start playback on a component connected 
via 

u, if the AV controller is on Standby, it will 

automatically turn on and select that component as 
the input source. Similarly, when the AV controller is 
set to Standby, all components connected via 

u 

will also go on Standby.

■ Direct Change

When playback is started on a component connected 
via 

u, the AV controller automatically selects that 

component as the input source.

■ Remote Control

You can use the AV controller’s remote controller to 
control your other 

u-capable Onkyo components, 

pointing the remote controller at the AV controller’s 
remote control sensor instead of the component. You 
must enter the appropriate remote control code first 
(see page 136).

Notes:
• Use only 

u cables for u connections. u cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

u jacks. You can con-

nect either one to the AV controller. The other jack is 
for connecting additional 

u-capable components.

• Connect only Onkyo components to 

u jacks. Con-

necting other manufacturer’s components may cause a 
malfunction.

• Some components may not support all 

u functions. 

Refer to the manuals supplied with your other Onkyo 
components.

• While Zone 2 or Zone 3 is on, the Auto Power 

On/Standby and Direct Change 

u functions do not 

work.

• Turning on the AV controller may cause a momentary 

power surge that might interfere with other electrical 
equipment on the same circuit. If this is a problem, 
plug the AV controller into a different branch circuit.

• Do not use a power cord other than the one supplied 

with the AV controller. The supplied power cord is 
designed exclusively for use with the AV controller 
and should not be used with any other equipment.

• Never disconnect the power cord from the AV control-

ler while the other end is still plugged into a wall out-
let. Doing so may cause an electric shock. Always 
disconnect the power cord from the wall outlet first, 
and then the AV controller.

u Components

Step 1:
Make sure that each Onkyo component is connected 
to the AV controller with an analog audio cable (con-
nection 

 in the hookup examples) (see pages 31 to 

Step 2:
Make the 

u connection (see illustration right).

Step 3:
If you’re using an MD, CDR, or RI Dock, change the 
Input Display (see page 55).

Step 1: 
Connect the supplied power cord to the AV control-
ler’s AC INLET.

Step 2:
Plug the power cord into an AC wall outlet.