ONKYO PR-SC5507 ユーザーズマニュアル
53
If you’ve fed your front speakers from the FRONT L/R
and SURR BACK L/R outputs for bi-amping, you must
change the “Speakers Type(Front)” setting. For hookup
information, see “Bi-amping the Front Speakers” on
page 21.
and SURR BACK L/R outputs for bi-amping, you must
change the “Speakers Type(Front)” setting. For hookup
information, see “Bi-amping the Front Speakers” on
page 21.
Notes:
• When bi-amping is used, the AV controller is able to
• When bi-amping is used, the AV controller is able to
feed up to 7.2 speakers in the main room.
• Before you change these settings, turn down the
volume.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Speaker Settings
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
q]/[w] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [
q]/[w] but-
tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.
If you change these settings, you must run
Audyssey MultEQ
Audyssey MultEQ
®
XT Room Correction and
Speaker Setup again (see page 56).
2. Speaker
Setup
1. Speaker
Settings
2. Speaker
Configuration
3. Speaker
Distance
4. Level
Calibration
5. Equalizer
Settings
6. THX Audio Setup
2–1. Speaker
Settings
Speakers Type(Front)
Normal
4
Use the Up and Down [
q]/[w] but-
tons to select “Speakers
Type(Front)”, and then use the
Left and Right [
Type(Front)”, and then use the
Left and Right [
e]/[r] buttons to
select:
Normal: Select this if you’ve con-
nected your front speakers
normally.
normally.
Bi-Amp: Select this if you’ve con-
nected your front speakers
for bi-amped operation.
for bi-amped operation.
Note:
Surround back speakers cannot be used
if you select “Bi-Amp”.
Surround back speakers cannot be used
if you select “Bi-Amp”.
5
Press the [SETUP] button.
The setup menu closes.
The setup menu closes.