ONKYO PR-SC5507 ユーザーズマニュアル

63

You can adjust the bass and treble for the front speakers, 
except when the Direct, Pure Audio or THX listening 
mode is selected.

■ Bass
You can boost or cut low-frequency sounds output by the 
front speakers from –10 dB to +10 dB in 2 dB steps.

■ Treble
You can boost or cut high-frequency sounds output by 
the front speakers from –10 dB to +10 dB in 2 dB steps.

Notes:
• This setting is not available when the multichannel 

Analog input is selected.

• To bypass the bass and treble tone circuits, select the 

Direct, Pure Audio or THX listening mode.

You can display various information about the current 
input source as follows.

Note:
This procedure can also be performed on the AV control-
ler by using its [DISPLAY] button.

The following information can typically be displayed for 
input sources.

*

If the input signal is analog, no format information is displayed. 
If the input signal is PCM, the sampling frequency is displayed. 
If the input signal is digital but not PCM, the signal format and 
the number of channels is displayed. For some digital input sig-
nals, including multichannel PCM, the signal format, number of 
channels, and sampling frequency is displayed. 
Information is displayed for about three seconds, then the previ-
ously displayed information reappears. 

r] and Down [e] 

Tip:
This procedure can also be performed 
on the remote controller by using 
[AUDIO] button (see page 112).

e, r DIMMER