ZyXEL Communications NWA-3550 ユーザーズマニュアル

Chapter 8 Wireless Configuration

NWA-3500/NWA-3550 User’s Guide

The NWA can act as a wireless network bridge and establish wireless links with 
other APs. You need to know the MAC address of the peer device, which also must 
be in bridge mode. 

The NWA can establish up to five wireless links with other APs.

Rates 
Configuration

This section controls the data rates permitted for clients. 

For each Rate, select an option from the Configuration list. The options 
are:

• Basic (1~11 Mbps only): Clients can always connect to the access 

point at this speed.

• Optional: Clients can connect to the access point at this speed, when 

permitted to do so by the AP.

• Disabled: Clients cannot connect to the access point at this speed.

Enable 
Antenna 
Diversity

Select this to use antenna diversity. Antenna diversity uses multiple 
antennas to reduce signal interference.

Enable 
Breathing LED

Select this check box to enable the blue “breathing” LED, also known as 
the NWA LED.

Clear the check box to turn this LED off even when the NWA is on and 
data is being transmitted and received.

Enable 
Spanning Tree 
Control (STP)

(R)STP detects and breaks network loops and provides backup links 
between switches, bridges or routers. It allows a bridge to interact with 
other (R)STP -compliant bridges in your network to ensure that only one 
path exists between any two stations on the network. Select this to 
activate STP on the NWA.

Enable 
Roaming

Roaming allows wireless stations to switch from one access point to 
another as they move from one coverage area to another. Select this to 
enable roaming on the NWA if you have two or more NWAs on the same 
subnet.

Note: All APs on the same subnet and the wireless stations must 

have the same SSID to allow roaming.

Apply

Click Apply to save your changes.

Reset

Click Reset to begin configuring this screen afresh.

Table 27   Wireless: Access Point