KitchenAid KERS807S プリント
30" Freestanding and Slide-In Electric Range
®
PRODUCT MODEL NUMBERS
OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
SLIDE-IN RANGE
COUNTERTOP PREPARATION
COUNTERTOP PREPARATION
KERS807S
KESS908S
KESS908S
Electrical: When a 4-wire or 3-wire,
single phase 120/240-volt, 60 Hz, AC-only
electrical supply is available, a 50 amp
maximum circuit protection is required (or,
if specified on the model/serial rating
plate, when a 4-wire or 3-wire single
phase 120/208-volt 60 Hz, AC-only
electrical supply is available, a 40 amp
maximum circuit protection is required),
fused on both sides of the line. The
model/serial number rating plate is located
on the oven frame behind the storage
drawer panel. A time-delay fuse or circuit
breaker is recommended.
single phase 120/240-volt, 60 Hz, AC-only
electrical supply is available, a 50 amp
maximum circuit protection is required (or,
if specified on the model/serial rating
plate, when a 4-wire or 3-wire single
phase 120/208-volt 60 Hz, AC-only
electrical supply is available, a 40 amp
maximum circuit protection is required),
fused on both sides of the line. The
model/serial number rating plate is located
on the oven frame behind the storage
drawer panel. A time-delay fuse or circuit
breaker is recommended.
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Instructions packed with product. Specifications subject to change without notice.
The cooktop sides of the slide-in range fit over the
cutout edge of your countertop.
cutout edge of your countertop.
If you have a square finish (flat) countertop and the
opening width is 30" (76.2 cm), no countertop
preparation is required.
opening width is 30" (76.2 cm), no countertop
preparation is required.
Formed front-edged countertops: Must have
molded edge shaved flat 3/8" (1.0 cm) from each
front corner of opening.
molded edge shaved flat 3/8" (1.0 cm) from each
front corner of opening.
Tile countertops may need trim cut back
3/8" (1.0 cm) from each front corner and/or
rounded edge flattened.
3/8" (1.0 cm) from each front corner and/or
rounded edge flattened.
If countertop opening width is greater than 30"
(76.2 cm), adjust the 3/8" (1.0 cm) dimension.
(76.2 cm), adjust the 3/8" (1.0 cm) dimension.
Countertop must be level. Place level on
countertop, first side to side; then front to back. If
countertop is not level, range will not be level.
Range must be level for satisfactory baking
performance.
countertop, first side to side; then front to back. If
countertop is not level, range will not be level.
Range must be level for satisfactory baking
performance.
Ref. 9763461
08-08-06
30"
(76.2 cm)
30
³⁄₄"
(78.1 cm)
³⁄₈"
(1.0 cm)
e
g
n
a
R
n
i
-
e
d
i
l
S
e
g
n
a
R
g
n
i
d
n
a
t
s
e
e
r
F
18" (45.7 cm) upper
cabinet to countertop
cabinet to countertop
30" (76.2 cm) min.
opening width
Cabinet door
or hinge
should not
extend into
the cutout.
C
4" (10.2 cm) min.
clearance from
both sides of
range to side
wall or other
combustible
material
clearance from
both sides of
range to side
wall or other
combustible
material
4" (10.2 cm) min.
clearance from
both sides of
range to side
wall or other
combustible
material
clearance from
both sides of
range to side
wall or other
combustible
material
13" (33 cm)
upper cabinet
depth
13" (33 cm)
upper cabinet
depth
For minimum
clearance to the
top of the cooktop,
see NOTE*.
For minimum
clearance to the
top of the cooktop,
see NOTE*.
30"
(76.2 cm) min.
opening width
30"
(76.2 cm) min.
opening width
Junction box - 8"
(20.3 cm) to 22" (55.9 cm)
from either cabinet, 7"
(17.8 cm) max. from floor
Junction box - 8"
(20.3 cm) to 22" (55.9 cm)
from either cabinet, 7"
(17.8 cm) max. from floor
18" (45.7 cm) upper
cabinet to countertop
cabinet to countertop
Cabinet door
or hinge
should not
extend into
the cutout.
30" (76.2 cm) min.
opening width
1/4"
(6.2 cm) radius
both corners
22 3/4" (57.8 cm)
opening depth
Cabinet opening dimensions shown are for
25” (64 cm) countertop depth, 24” (61 cm)
base cabinet depth and 36” (91.4 cm)
countertop height.
25” (64 cm) countertop depth, 24” (61 cm)
base cabinet depth and 36” (91.4 cm)
countertop height.
NOTE: 24" (61 cm) min. when bottom of wood or metal
cabinet is protected by not less than 1/4" (0.64 cm)
flame retardant millboard covered with not less than
No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,
0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
cabinet is protected by not less than 1/4" (0.64 cm)
flame retardant millboard covered with not less than
No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,
0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) min. clearance between the top of the
cooking platform and the bottom of an unprotected wood
or metal cabinet.
cooking platform and the bottom of an unprotected wood
or metal cabinet.
If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
Freestanding Range
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)
countertop; front of oven door protrudes 1" (2.5 cm) beyond
24" (61 cm) base cabinet.
24" (61 cm) base cabinet.
Slide-in Range
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)
countertop; front of oven door protrudes 1
³⁄₄" (4.4 cm) beyond
24" (61 cm) base cabinet.
A.
5³⁄₄" (14.6 cm)
B. 30" (76.2 cm)
C. 41
C. 41
³⁄₄" (106 cm) overall
height with leveling legs
screwed all the way in
screwed all the way in
D. 36" (91.4 cm) cooktop trim
height with leveling legs
screwed all the way in*
screwed all the way in*
E. 30" (76.2 cm)
F. 27
F. 27
¹⁄₄" (69.2 cm) max. from
handle to standoff at back of
range**
range**
G. Model/serial number plate
(located on the right-hand side
oven door trim)
oven door trim)
A
B
C
D*
E
F**
G
A. 30
¹¹⁄₁₆" (77.6 cm)
B. 35
⁵⁄₈" (90.5 cm) height to
underside of cooktop edge
with leveling legs screwed all
the way in*
with leveling legs screwed all
the way in*
C. Model/serial number plate
(located on the right-hand side
oven door trim)
oven door trim)
D 30" (76.2 cm)
E. 27¼" (69.2 cm) from handle
to standoff at back of
range**
range**
F. 23" (58.4 cm) countertop
notch to rear of cooktop
C
B*
A
D
E**
F